@KalmanFilter

Simulation of Conventional AM modulation (including Envelope detector)

这是一个关于Wigner-Ville分布的线性预测算法的程序,大家看看可以作为参考资料研究一下了.(This is one of the Wigner-Ville distribution of the linear prediction algorithm procedures, We can look at the study as a reference.)

OPQSK调制信号的载波相位/频率以及时间同步算法的实现与验证，很有使用价值(OPQSK modulated signal carrier phase/frequency and time synchronization algorithm and validation, very valuable)

This file consists matlab programs implemented in image compression in Digital image processing

说明：  matlab在控制系统方面的讲义，供学习参考(matlab lecture notes in control systems for the study reference)

convolution between two sequences

说明：  在simulink下建立了OFDM系统的仿真模型，并对所建模型进行了分析(The simulation model of OFDM system is established in Simulink, and the model is analyzed)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

xt_mark - Netfilter module to match NFMARK value.

dfig simulation is explained with the help of matlab