Beamform

一维小波包在matlab分解六层分解，与重构，可得高低频。与原高低频对比。( One dimensional wavelet packet decomposition in the MATLAB decomposition of the six layer, and the reconstruction can be HISTEP low frequency. Contrast with the original high and low frequency. )

利用文中命令码，可以在ANSYS中实现如何输入地震波，这对结构动力分析非常重要！(Using text command code, can be implemented in ANSYS how to input seismic wave, which is very important for structural dynamic analysis!)

使用Matlab实现特殊矩阵，对初学Matlab的人很有帮助(It has benefits for learners)

机器人的PID控制之确定性单臂机械手的PD+前馈控制（先进进PID控制MATLAB仿真第二版），已通过测试。 (PID control of robot uncertainty arm manipulator PD+ before feed-forward control (Advanced PID Control MATLAB simulation), has been tested.)

微型逆变器初始化，简单易学，大家互相分享源码。(Micro-inverter initialization, easy to learn, we share with one another source.)

it is a projet of some student who upload on web

总结了matlab与vc混合编程的三种常用方法，并结合了具体的实例，简单介绍了基本的操作(Matlab and vc summarized three common hybrid programming method, and specific examples, a brief introduction of the basic operations)

数据链路层滑动窗口协议的设计与实现源码 信道模型为8000bps 全双工卫星信道，信道传播时延270 毫秒，信道误码率为10-5，信道提供字节流传输服务，网络层分组长度在240~256字节范围。(Sliding window data link layer protocol design and implementation of source-channel model 8000bps full-duplex satellite channel, the channel propagation delay 270 ms, the channel bit error rate of 10-5, the channel provides a byte stream transfer service, network layer packet length in the range of 240 to 256 bytes.)

几个轴承类的matlab文件 里面包含几个实例(Several bearing class matlab file which contains a few examples)

固高控制卡程序,pt控制方式,需要的可以下载看看.(Googol control card program)