1572-Introduction-to-Using-OPNET-Modeler-Network-

说明：  5. 在三条径的瑞利信道中，对于直接序列扩频： (1) 请设计DS-CDMA一种具体的码分导引辅助的信道估计方法，接收机分别采用等均益合并、最大比合并。用Simulink进行仿真，画出比特信噪比与信道估计均方误差的关系曲线和比特信噪比与误码率的关系曲线。 (2) 设频率已经同步，请设计DS-CDMA一种具体的单停顿滑动相关时间同步方法，用Simulink进行仿真，画出比特信噪比与捕获概率的关系曲线。 (3) 设时间已经同步，请设计DS-CDMA一种具体的频率同步方法，用Simulink进行仿真，画出比特信噪比与频率同步误差的关系曲线。(5. In three-path Rayleigh channel, for direct sequence spread spectrum: (1) please design a specific code division navigation aided channel estimation method for ds-cdma, and adopt equal-beneficial combination and maximum ratio combination for receivers respectively.Simulink is used to simulate and draw the relationship curve between bit SNR and channel estimation mean square error and the relationship curve between bit SNR and bit error rate. (2) assuming that the frequency has been synchronized, please design a specific single-stop sliding correlation time synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and the acquisition probability curve. (3) if the time has been synchronized, please design a specific frequency synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and frequency synchronization error curve.)

dqpsk的完整調製解調，采用costas載波同步(DQPSK complete modulation and demodulation, using Costas carrier synchronization)

ANSYS里的数据导入MATLAB，用于ANSYS与MATLAB交换数据。(The data in ANSYS is imported into MATLAB)

principle_of_communication……matlab(principle_of_communication.matla)

OFDM系统在QPSK与16QAM调制下，误码率比较程序，希望对大家有一定用处(OFDM system with 16QAM QPSK modulation, error rate procedures, We hope to have some use)

comparaison of photovoltaic mppt algorithms

Blob Test extends SQLite Test Source Code for Andriod.

利用lms算法和rls算法，对通过给定系统h的随机信号进行自适应滤波，通过抽头w对系统进行逆辨识与辨识，同时产生MSE 即均方误差，来描述对信号恢复的效果。(Using lms algorithm and rls algorithms h through a given system adaptive filtering of random signals, the system through the tap w reverse identification and recognition, while the mean square error MSE generated to describe the effect on signal recovery.)

说明：  TI RTOS 教材，难得好资料，基于TI RTOS软件开发人员的必备参考(TI RTOS handbook, show how to use TI RTOS)

OFDM系统的自适应功率和比特分配算法，实现系统资源的自适应分配（4)－－原创(adaptive allocation for OFDM system)