SCSToolboxV31

将同频信号用fastICA算法进行分离，其中包括各种调制信号。MPSK，QAM，MASK(The same frequency signal separation algorithm using fastICA, including a variety of modulated signals. MPSK, QAM, MASK)

ecg matlab source code for medical application

matlab ofdm signal simulation. PAPR(peak to average power ratio) modeling.

open the zip file .. here you will find some help documents and then you can use those to get some valuable indformation about image processing

希尔伯特黄变换,包括固有模态的求解算法以及经验模态分解的算法。利用此程序可以对一个复杂的信号分解出其内涵的确定性信号。(Hilbert Huang transfermation)

利用FFT变换，对sine2进行频谱分析，画出频谱图 利用fir源程序对输入波形sine2进行低通滤波，并将结果输出至result.dat (Using FFT transform, spectral analysis of sine2, draw the spectrum graph fir the use of the input waveform sine2 source for low-pass filtering, and the results output to result.dat)

对原始灰度图像进行图像压缩，对此图进行 8×8 DCT 变换后，分别只保留 DC系数，以及保留前 4、8、16 个变换系数(DC＋AC) ，然后再分别进行 IDCT 变换 (The original gray image compression, this map for 8 × 8 DCT transform, respectively, to retain only the DC coefficient, and to retain the former 4,8,16 months transform coefficients (DC+ AC), and then separately IDCT transform)

Modeling of PID for boost converter

应用MATLAB工具箱在VC++中实现神经网络的程序设计(MATLAB toolbox application in VC++ in the realization of neural network programming)

小波神经网络3 一共是3个哦(Wavelet neural network is a total of 3 Oh 3)