daqmx_2channel_oscilloscope

电机控制的一部分程序 还没有编完 以后陆续上传完整程序(Simulation odule unctions)

说明：  labview串口接收、发送（分开）程序以及总通信程序(LabVIEW serial port receive, send (separate) program and general communication program)

基于声卡的虚拟仪器示波器，通过声卡进行数据采集，再由LABview显示波形。(A virtual instrument oscilloscope based on sound card is used to collect data through a sound card, and then the waveform is displayed by LABview.)

LabVIEW编写的一个信号发生器程序，可选择正弦波、方波、三角波等(A signal generator program written by LabVIEW can select sine wave, square wave, triangle wave, etc.)

说明：  基于LABVIEW软件采集电压电流信号，运用DAQmx建立任务(Acquisition of voltage and current signals)

说明：  LABVIEW机器视觉通用框架,直接套用于工程项目(LAbview machine vision general framework)

数据采集卡采集拉力值，与预先设定的拉力值进行比较，然后PID运算，控制相应的PWM占空比输出，最终控制电机的速度(The data acquisition card collects the pull value and compares it with the pre-set pull value. Then the PID arithmetic is used to control the output of the corresponding PWM duty cycle, and finally the speed of the motor is controlled.)

ModBus CRC16校验 LabView程序源码(ModBus CRC16 check LabView program source code)

labview实例教程 LABVIEW基本知识和仿真 仿真程序 (LabVIEW examples tutorial)

LABVIEW的中文转成Unicode码的模块，可以作为发送短信模块的子VI使用。(LABVIEW of Chinese into Unicode code module, you can send SMS module as a sub VI uses.)