mega128_38KHZ

在PSIM中使用SVPWM进行调制所需要的应用程序，使用C++编程(SVPWM application of PSIM)

cc2530读取ADXL345加速度计的数据的相关函数，包括读，写，配置等等。 使用P1_4~P1_7作为SPI,与ADXL345通信。 (cc2530 read ADXL345 accelerometer data related functions, including reading, writing, configuration, and so on. Use P1_4 ~ P1_7 as SPI, and communications ADXL345.)

基于stm32的 hal库的 mpu6050六轴驱动程序。可读取角速度 加速度(Based stm32 of hal library mpu6050 six-axis driver. Read angular velocity acceleration)

飞思卡尔16位单片机MC9S12DG128的例程，很全的(Freescale 16-bit microcontroller MC9S12DG128 routine。)

三轴加速度传感器ADXL345的驱动程序,基于STM32F4.(Triaxial accelerometer ADXL345 drivers, based STM32F4.)

基于M0516的魔球灯控制程序，内含原理图，功能有内置PWM加模拟PWM线性调光，炫耀的自走程序与声控程序，主从控制模式，IIC协议，485通讯DMX512协议，74HC595控制四位3461共阴数码管，ULN2803电机驱动程序(M0516 based magic ball lamp control procedures, the enclosed schematic diagram, function has a built-in PWM analog PWM linear dimming, showing off the go program with voice control, master-slave control mode, the IIC agreement, 485 communication DMX512 protocol, 74 hc595 are needed to control the four digital tube, 3461, a total of Yin ULN2803 motor drivers)

用51单片机模拟dds产生正弦波，方波，三角波，幅度频率可控。(Dds generated using 51 MCU simulation sine, square, triangle wave, amplitude frequency control.)

用Visual C++ 6.0实现的一个VSP程序。包你看后受益匪浅。(with Visual C 6.0 of a VSP procedures. After looking at the package you benefited.)

lpc2119uart.rar是nxp公司的嵌入式芯片lpc2119的连习程序,大家可以用来练习串口通讯的编程(lpc2119uart.rar is nxp chip companies lpc2119 embedded link learning process, everyone can be used to practice serial communication programming)

用PIC实现写种子工具,用232协议转换SPI协议实现.(Write-seed with PIC tools, protocol conversion with 232 SPI protocol.)