STEP_MOTOR

PID永磁同步电机无位置传感器控制，采用F28335，程序是在ti程序基础上改的。(PID permanent magnet synchronous motor without position sensor control with F28335, program is changed in ti procedures based on the.)

一个用于DSP和FPGA通讯的测试程序，FPGA用EMIF接口接入(A test program for the DSP and FPGA communication, FPGA with the EMIF interface access)

check usb dongle type

DSP28035的应用程序，是计时器的测试用例，经过验证(The application program of DSP28035 is a test case of timer, which has been verified.)

5509A的入门程序，可以方便设置主频，XF输出方波信号。对初学者很好帮助。(5509A of the entry process, you can easily set the frequency, XF output square wave signal. Very good help for beginners.)

TMS320C6678的SPI_EDMA回环测试程序，使用CSL库编写的程序，里面可能使用pdk6670的相关库函数，但是可以作为参考(TMS320C6678 of SPI_EDMA loopback test procedures, programs written using the CSL library, which may be related to the use of library functions pdk6670, but can be used as reference)

模数采样,以及产生PWM波的程序，适用于DSP28335(Modulus sampling, and generate PWM wave procedures, applicable to DSP28335)

此程序是TMS320F28335与网络芯片ENC28J60之间的以太网通信，程序接口采用的是中断的方式，程序ping命令测试通过。(This program is TMS320F28335 with Ethernet communication between network chip ENC28J60, program interface uses an interrupt, the program ping command to test.)

实现三维重建功能 不很全面只是给刚接触的朋友一点指引(Three-dimensional reconstruction of functions is not very comprehensive guide to the new to the friends that)

TI dsp的spi编程例子，基于keystone架构，很好的入门资料(example of program spi in dsp )