Good-PPT---Image-Registration.pdf.tar

matlab data rate calculations for OFDMA systems

Neural Network with multiple inputs and multiple output with training data in file name Twod is trained using steepest descent algorithm.After training data ,we can test a new set of data

Program for work with password. We can enter the password or edit password

说明：  基于股票分析方法的电力系统负荷预测：主要思路是从过去的负荷中得出对应的DIF值、DEA值、MACD值。然后再通过DIF去估测明天DIF估计值、DEA估计值、MACD估计值。然后又通过DEA、MACD估计值算出一个新的DIF估计值。再将这两个DIF估计值算术平均得出一个新的DIF估计值，然后反推出负荷的预测值，这样就完成了负荷预测。(The main idea is drawn from the past load values corresponding to the DIF, DEA value, MACD value. And then estimate DIF ,DEA,MACD in tomorrow use the past DIF , DEA , MACD. Then through the DEA, MACD calculate a new estimate of DIF. Then the arithmetic average of the two estimated DIF derived a new estimate of DIF, and then introduce predictive value of load, so that is the completion of the load forecast. )

A sourcecode for train adeline algorithm.

MPC cody of a dc motor

3D PLOT USING MATLAB IN PSCAD WARNING * This case only works if you use the Compaq/Intel Fortran Compiler. A T_D_PLOT component. It provides the interface to a MATLAB function t_d_plot . It is a user-defined function and the m-file T_D_plot.m contains its definition. This component plots a 3-dimensional curve. Input: X, Y and Z values of the point to be plot Output: a dummy output of value zero Parameters of T_D_PLOT component.

内有鸢尾花数据的5折交叉验证实验代码，采用的分类器是贝叶斯分类器。(There is a 5-fold cross-validation experiment code for the iris data, and the classifier used is a Bayesian classifier.)

利用matlab/simulink建模做的制动转矩的分配，可以非为制动转矩和再生转矩两种(Using Matlab/Simulink modeling to do the distribution of the braking torque, non-braking torque and regenerative torque two kinds。)

说明：  用matlab建立模型设计fpga，文章采用系统模型(Using matlab to establish model design fpga, articles used system model)