inverter

51单片机C语言学习，C语言来编写单片机程序。Proteus仿真。(51 MCU C language learning, C language to write MCU program. Proteus simulation.)

it is keil-c program for run lcd on lpc1768 ECA.com

说明：  R5F56218程序，ADC采集电压传输(R5f56218 program, ADC acquisition voltage transmission)

Samsung KS0719 graphical LCD (SPI) This driver allows to draw points and to write characters on this graphical display.(Samsung KS0719 graphical LCD (SPI) This dr iver allows points to draw and to write characte rs on this graphical display.)

内有PID源码驱动，包含位置式PID和增量式PID。PID通过结构体定义，可同时定义多套参数，并同时使用，并不会相互影响。(There is a PID source driver, including position PID and incremental PID.PID through the structure definition, can be defined at the same time multiple sets of parameters, and use at the same time, will not affect each other.)

Delphi:Delphi模拟交通信号红绿灯的控制程序，设定倒计时，时间到则亮起对应的信号灯，改进一下写进单片机哦。 (Delphi: Delphi simulated traffic signal lights control procedures, set the countdown time to the corresponding lights illuminate improve written about SCM, oh.)

使用VB与PIC采集,采用软件中断方式，使用研华1710集成卡。(Using VB with PIC acquisition, the software interrupt, use the the Advantech 1710 integrated card.)

通过 Modbus 通讯 RS485 型物理链路，或装有适当变换器的其他接口使 Sepam 能 与远程监控系统连接。 Sepam 采用的 Modbus 规约与 RTU Modbus (1) 规约的子集兼容 ( 一个 Modbus 主 机可以同多个 Sepam 单元通讯 )。 Sepam 永远是子机 ( 从站 )。 所有 Sepam 单元均可配置 ACE949-2 ( 二线 ) 或 ACE959 ( 四线 ) 接口与通讯网络 连接。 RS485 和 ACE937 可连接到通讯网络，光纤通讯星形系统。(Communication via Modbus RS485 type physical link, or fitted with suitable converters other interfaces can make Sepam Connection with a remote monitoring system. Sepam uses a subset of the Modbus protocol with RTU Modbus (1) of the Statute compatible (a Modbus master Machine unit can communicate with a plurality of Sepam). Sepam is always a slave (slave). All Sepam unit can be configured ACE949-2 (wire) or ACE959 (four-wire) communications network interface connection. RS485 and ACE937 can be connected to the communications network, fiber-optic communication star system.)

说明：  STM32F103控制蜂鸣器鸣叫，基于keil4软件(STM32F103 Control Buzzer)

二氧化锆氧气传感器的氧气含量测量程序（此程序已经应用到产品）(Procedures for the measurement of oxygen content of two zirconia oxygen sensor (this procedure shall be applied to the product))