taskPower

三相桥双极性PWM控制Simulink仿真，叠加一些其他信号，另加一滤波器观看PWM经过低通滤波后的波形，适合电力电子初学者(Three-phase bridge bipolar PWM control Simulink simulation, superimposed a number of other signals, plus a watch PWM filter through after the low-pass wave filter for power electronics for beginners)

利用DCT进行图像压缩（首先将图像分割成8×8的图像，对每个子图像进行DCT，这样每个子图像有64个系数，舍去50％小的变换系数，进行2：1的压缩。）(Using DCT for image compression (first image into 8 × 8 image, for each sub-image DCT, so that each sub-image by a factor of 64, rounding 50 of the small transform coefficients, the 2:1 compression.))

《图象处理》全部编码~~~~matlab~~~~(matlab~)

自适应波束形成图演示，不同条件下波束形成的性能，适合初学自适应信号处理的朋友(adaptive beamforming of different situations,suitable for beginners)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

The probability that a hand-off occurs as a function of the distance between the mobile & its serving base station. result is plotted in probability of had off Vs distance d!

OFDM简易模型matlab simulation(Aesthetic design screensavers)

在电力系统中，计算整个网络的网损的程序。(In the power system, calculation of network network loss procedures. )

对EMD算法的改进，边界的处理，极值点的处理，都有改进(EMD algorithm improvements, the processing of the border, the extreme points of treatment, has improved)

matlab实现计算机视觉三维重建 摄像机标定新算法,用一个子函数计算出两组运动组的参数 本程序用于调试摄像机标定新算法(摄像机标定新算法,用一个子函数计算出两组运动组的参数 本程序用于调试摄像机标定新算法)