mfilter

一个粒子群算法的matlab程序代码 很经典的 对于研究粒子群算法的人很有帮助( pso matlab)

matlab pso-xc evolve2.m matlab pso-xc evolve.m

It s matlab programs for Hamming codes. They re Hamming 4/7 and Hamming 11/14. Including encoder, decoder. I hope you enjoy them!

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

Q函数的计算雷达系统设计中的雷达中的常见函数设计(Q function)

用MATLAB开发的旅行商问题，可以设定不同的初始条件，进行求解。求解速度快！(Using MATLAB development of traveling salesman problem, you can set different initial conditions, to solve. Solving faster!)

分析剖析器，深入的综述数据科学家和他们的工作是应用数据科学的方法到专业社区的结果。(Analyzing the Analyzers: An Introspective Survey of Data Scientists and their Work is the result of applying the methods of data science to our own professional community. )

编写了MATLAB程序生产和扩频码进行仿真，仿真程序从发送方完成通道的接收端，得出在不同的扩频码，在不同的信噪比即误码率的图形比较直接序列扩频通信系统原理，改善系统性能的度(Written MATLAB program to produce and direct sequence spread spectrum communication system principle of spreading codes for simulation, emulation program to complete the channel from the sender to the receiver end, draw graphics comparison at different spreading code, the bit error rate under different SNR i.e., the degree of improvement of the system performance)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

F2T变换 (F2T transformation )