sstmm32_adc__t

ATMEGA8_ LTC2400 6位半表头程序 LTC2400最高测量电压为5.3V，超过5.3V或反接都会烧掉。 模拟部分供电最好经过7815稳压，最高输入电压不宜超过18V。 模拟电路与数字电路分开供电。 不要使用开关电源或PWM升压、降压电路供电 (ATMEGA8_ LTC2400 6 ½ -digit meter program LTC2400 highest measured voltage is 5.3V, 5.3V or reverse will be burned over. After 7815 some of the best analog power supply voltage, the maximum input voltage should not exceed 18V. Separate analog and digital circuit power supply. Do not use a switching power supply or PWM buck, boost circuitry)

DMA9061A基于LPC2300的源代码(dma9061a with lpc2300 s source code)

arm11 初学源代码 有些事自己完成 有些是经过修改的。希望对大家有帮助(arm program.)

at91sam7a3在iar下的sdcard例程，调试通过，可以作为学习参考(at91sam7a3 the sdcard routine, under the iar through debugging, can be used as a study reference)

铁电MB85RC64驱动程序，需要的可以下载看看，应用在STM32上面的。(Ferroelectric MB85RC64 drivers need to be downloaded to see the application in the STM32 above.)

基于LPC17xx的GPIO驱动，开发环境为Kiel，以调试通过(The routines of LPC1768 is complete the Ethernet control function, through this source code can achieve the 1768 Ethernet connection, have debugging, through, welcome to download)

stm32 双串口通信 串口1对串口2的异步通信(stm32 Dual serial communication)

说明：  ARM series of nuclear CORTEX-M3 STM32 development routine

捕获到人体心电信号后，用STM32编程显示波形程序(After capturing the human ECG, waveform display program with STM32 programming)

stm32中准确延时用的文件,因为时钟速度过快且应用广，要实现ms的延迟是很困难的，所以用嘀嗒时钟。(make sure the delay time is just the time we wanted.)