dft

属于MATLAB编程代码，可用于参数估计及寿命预测(Can be used for parameter estimation and life prediction)

此程序是TMS320F28335与网络芯片ENC28J60之间的以太网通信，程序接口采用的是中断的方式，程序ping命令测试通过。(This program is TMS320F28335 with Ethernet communication between network chip ENC28J60, program interface uses an interrupt, the program ping command to test.)

说明：  cpofdm信道模型仿真，通过仿真得到cpofdm信道模型的复杂度和在各种信噪比下的误码率(Through the simulation of cpofdm channel model, the complexity of cpofdm channel model and the bit error rate under various SNR are obtained)

基于模拟退火算法的光学模式转换，为模分复用一种高效转换算法。(Based on the optical mode conversion of simulated annealing algorithm, a high efficiency conversion algorithm is used for modular division multiplexing.)

DSP320F280X GPIO驱动流水灯的程序 (DSP320F280X GPIO driver light water programs)

说明：  压缩包内包含牛顿插值和牛顿迭代的MATLAB程序。(The MATLAB program contains Newton interpolation and Newton iteration in the zip file.)

通信天线建模与MATLAB仿真分析书中10-4题目代码(Lossy Extractio Communication Antenna Modeling and MATLAB Simulation Analysis Book 10-4 Topic Code)

说明：  基于matlab的地图栅格法建模，可根据txt自定义障碍物。(Based on the map grid method of MATLAB, the obstacles can be customized according to TXT.)

simulink gps信号生成 信号包括CA码，D码，导航电文(simulink gps signal generating signals include CA code, D code, navigation message)

此程序主要功能是在风向固定，风速变化的情况下，求总风场输出的功率(The main function of this program is fixed in the wind, the wind speed changing circumstances, seeking total power output of wind farms)