HW3

Induction machine MAT/Simulink

设计一CQMFB，低通滤波器H_0 (z)来自一半带滤波器。该半带滤波器的长度为47，通带截止频率ω_p=0.42π，试给出H_0 (z)，H_1 (z)，G_0 (z)，G_1 (z)的幅频响应，单位抽样响应并画图。试着产生一信号，它由两个正弦加白噪声组成，一个在低频，一个在高频，正弦的频率及和白噪声的信噪比自己给定。试用所设计的滤波器组对该信号进行分解和重建。比较重建后的效果，并对结果继续进行分析。(Design a CQMFB, low pass filter H_0 (z) the half-band filter. The length of the half-band filter 47, passband cutoff frequency ω_p = 0.42π, try to give H_0 (z), H_1 (z), G_0 (z), G_1 (z) of the amplitude-frequency response, the unit sample response and Paint. Try to generate a signal that consists of two sinusoidal composition plus white noise, a low frequency, a high frequency in the signal to noise ratio, frequency and sine and white noise of its own given. Trial designed filter group that signal decomposition and reconstruction. Results were rebuilt, and the results continue to be analyzed.)

说明：  “基于Matlab的MIMO通信系统仿真”，，收获良多，特将其记录下来("Simulation of MIMO Communication System Based on MATLAB", which has gained a lot, is specially recorded.)

自适应滤波器程序，选用电力系统谐波信号作为输入。其中包括了wiener滤波器，kalman滤波器，LMS算法，RLS算法，LSL算法，FTF算法。所有程序均为本人自编，并且标注了编程所参考的书籍及页数，经过调试，完全正确，请放心使用。(Adaptive filter procedures, selection of power system harmonics signal as input. Including the wiener filter, kalman filter, LMS algorithm, RLS algorithm, LSL algorithm, FTF algorithm. All Programs are my own, and marked by a programming reference books and pages, after debugging, completely correct, please rest assured that use.)

光纤陀螺输出误差的allan方差分析，使用的matlab仿真软件以及实际陀螺采样的数据进行分析。详细分析了5个误差的大小及其拟合曲线(FOG output error of the allan variance analysis, the use of matlab simulation software as well as actual gyroscope data sample for analysis. A detailed analysis of the size of error of 5 and its fitting curve)

usefull commands for matlab introductions and mathematical fuctions

多种图像边缘检测方法研究源代码,对图像边缘检测方法进行了matlab仿真分析(The image edge detection methods)

偏振控制器，利用绑架球算法对QHQ型进行方位角的误差分析(Polarization controller, using the kidnapping of QHQ type ball algorithm for the azimuth error analysis)

implementation of jpeg compression

基于matlba的常见信号设计，全部都经过实验验证，可作为子函数使用(Common Signal Design matlba based, all through experimental verification, use as Functions)