AVR_FINAL

4psk信号的蒙特卡洛误码率仿真，与理论误码率的对比(Monte Carlo signal 4psk BER simulation, and theoretical bit error rate comparison)

异步电机矢量控制仿真模型，采用间接磁场定向控制策略，电机模型没有采用matlab自带电机，而是根据两相旋转坐标系下的电机方程自己搭建了一个电机模型。(Induction motor vector control simulation model, using the indirect field oriented control strategy, the motor model comes with no motor using matlab, but according to the two-phase rotating coordinate system of the motor equations built himself a motor model.)

全相位时移相位差频谱校正法的文章，帮助大家学习。(All phase shift the phase spectrum correction method, article, and help them to learn)

kalman filter is described in this code and implemented

一个处理hough变换的源码，希望大家能有点用，不过是一个matlab的源码，一会再传一个C的(Hough transform a deal with source code, hope that we can use a little bit, but is a matlab source code, one would send a C of)

说明：  modulation classification

说明：  matlab自回归马尔可夫转换模型仿真估计与预测(matlab autoregressive Markov switching model simulation estimates and projections)

collision detection algorithm in matlab

说明：   MATLAB的NSGA改进后的算法(MATLAB' s NSGA improved algorithm)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):