YUANLP

说明：  利用matlab编写的小波分解分频和除躁程序，分为高低频率，并除去噪声，达到较好的效果。(Prepared using matlab wavelet decomposition impatient frequency and in addition to procedures, divided into high and low frequency, and to remove noise, to achieve good results.)

运用KPCA方法在ORL人脸库上进行人脸识别，分类器为最近邻分类器。(KPCA method using ORL face database for face recognition, classification for the nearest neighbor classifier.)

VanderPoll oscilator simulation

1．产生一个连续信号，包含低频，中频，高频分量，对其进行采样，进行频谱分析，分别设计三种高通， 低通，带通滤波器对信号进行滤波处理，观察滤波后信号的频谱。 2.采集一段含有噪音的语音信号（可以录制含有噪音的信号，或者录制语音后再加进噪音信号），对其进行 采样和频谱分析，根据分析结果设计出一合适的滤波器滤除噪音信号(1. Produce a continuous signal, including low-frequency, medium frequency, high-frequency components, its sampling, spectral analysis, are designed for three high-pass, low pass, band-pass filter the signal filtering treatment to observe the signal spectrum after filtering. 2. Acquisition section of the speech signal contains noise (can record a signal containing noise, or voice recording, additional noise after the signal), its sampling and spectral analysis, based on an analysis of the results to design a suitable filter to filter out one noise signal)

this is made in matlab hand detection using gaussian mixture algorithm , some other people can use these file to make more advancemnt in it, improvement can be made in these files

Communication walsh code generator for modeling.

说明：  自适应控制算法的另一个Simulink模型，可运行，是无模型参考控制算法的一个应用实例，供共同学习和交流(Adaptive control algorithm to another Simulink model to run, there is no model reference control algorithm of an application example for the common learning and exchange)

With PRP conjugate gradient method for solving unconstrained problem

基于matlab开发软件 的选择输入类型的数值计算仿真程序 迭代方法包括 1可自启动的4阶龙格库塔法 2需要使用其他方法启动的阿达姆斯法(Matlab-based software development selective types of numerical simulation program including an iterative method can be Since the start of the four-Runge- Kutta method need to use two other methods activated ADAMS France)

color mapping using look up table