ad7792_rx62n

传送指令MOV的学习程序，三菱PLC控制程序(A learning program for sending instruction MOV)

data mining presentation written in Turkish.

CCS所有功能例程,实现AD采样、pwm产生等功能(CCS all functional routines, realize AD sampling, PWM generation and other functions)

AVR单片机对舵机的精确控制 含源代码及工作原理(AVR microcontroller for precise steering control)

这是采用c8051f340对24c64进行读写的程序，新鲜出炉的，参考了新华龙官网程序，双字节目标存储地址哦！(This is used c8051f340 read and write procedures for 24c64, freshly baked, with reference to the new Hualong Guan network program, the target memory address byte Oh!)

说明：  STC12C5A60S2-串口1-读取ID(STC12C5A60S2-UART1 ,READ ID)

main.c已详尽注释连接的引脚 和 调试助手参数。STM32分别以串口,硬件SPI,模拟并口驱动CH395,4个socket连接, 原路返回上位机发送的数据。串口模式支持更改工作波特率，硬件SPI速率最高36MHz, 模拟并口较快，这三种模式支持在stm32任意型号下。(Main.c has commented on pins and debugging assistant parameters in detail. STM32 drives CH395 and 4 sockets by serial port, hardware SPI and analog parallel port respectively, and returns the data sent by the host computer in the original way. Serial mode supports changing working baud rate. Hardware SPI rate is up to 36MHz and analog parallel port is fast. These three modes support any model of stm32.)

51单片机片上串口控制GPRS模块。用KEIL 软件调试成功。(51 MCU on-chip serial port to control the GPRS module. KEIL software debugging success.)

基于51单片机的信号发生器 四种波形显示 有级调频(Based on 51 single-chip signal generator)

使用AVR单片机，制作的无线滚码遥控器代码。其中包括无线滚码算法实现，和加密算法实现。(use AVR microcontroller, produced by wireless remote control code rolling code. Roller including wireless code algorithm, and encryption algorithm.)