登录
首页 » matlab » rscore

rscore

于 2013-09-09 发布 文件大小:1KB
0 230
下载积分: 1 下载次数: 13

代码说明:

  利用matlab实现归一化处理,可用处理大量数据(Using matlab to achieve normalization processing, handling large amounts of data available)

文件列表:

rscore.m,1369,2010-01-17

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • cum4mus
    运用4阶高阶累积量的MUSIC算法具有更高的测向精度,需要较低的信噪比(Using 4-order cumulant of the MUSIC algorithm has higher accuracy of finding the need to lower signal to noise ratio)
    2010-08-04 14:18:12下载
    积分:1
  • New-Folder-(2)
    功能实现FSK的调制与解调,采用simulink进行仿真。(The file is used to realize the function of modulation and demodulation of FSK by using simulink to simulate the file.)
    2012-11-27 16:06:03下载
    积分:1
  • 201308flowshop-GA
    遗传算法的编码实现 在MATLAB环境中(Coding Genetic Algorithm in the MATLAB environment)
    2013-11-22 16:47:04下载
    积分:1
  • stm32-foc-firwmare-libraries-v2.0
    永磁同步电机矢量控制程序,位置与角度判断可通过霍尔位置传感器,编码器得到,其中也含有无位置传感器程序(Permanent magnet synchronous motor vector control program, to determine the position and angle through the Hall position sensors, encoders get, which also contains the program without position sensors)
    2014-02-20 09:03:43下载
    积分:1
  • fpa_demo
    花朵授粉算法是通过模拟自然界中花朵授粉过程构造出的一类随机搜索算法,体现了自然的择优机制。根据植物的授粉对象不同,可分为自花授粉(self-pollination)和异花授粉(cross-pollination)两类。(This demo program contains the very basic components of the flower pollination algorithm (FPA), or flower algorithm (FA), for single objective optimization. )
    2021-03-19 08:49:19下载
    积分:1
  • cressman_interp
    说明:  客观分析法插值SST程序,包括等权重法,cressman法和Barnes法三种客观分析方法。(Objective analysis method interpolation SST program includes three objective analysis methods: equal weight method, Cressman method and Barnes method.)
    2020-10-19 11:23:08下载
    积分:1
  • Lab10_TrafficLight
    TM4C基础学习实验,交通信号灯控制编程实验(TM4C based learning experiments, traffic signal control programming experiment)
    2014-12-27 13:31:57下载
    积分:1
  • PSD2_2_PSD1
    二维功率谱密度换算一维功率谱密度的程序,对表面质量的计算尤为使用(two dimensional power spectral density to one dimensional psd)
    2009-03-05 14:38:02下载
    积分:1
  • chap4
    .已知某炉温控制系统,要求温度保持在600℃恒定,针对该控制系统有以下控制经验: (1)若炉温低于600℃,则升压,低的越多升压越高; (2)若炉温高于600℃,则降压,高得越多降压越低; (3)若炉温等于600℃,则保持电压不变。 设模糊控制器为一维控制器,输入语言变量为误差,输出为控制电压。输入输出变量的量化等级为7级,取5个模糊集,试设计隶属度函数误差变化划分表,控制电压变化划分表和模糊控制规则表。 (Known for a temperature control system that requires a constant temperature is maintained at 600 ℃, the following control experience for the control system: (1) If the furnace temperature is below 600 ℃, the step-up, the more the higher the lower the boost (2) if the furnace temperature is higher than 600 ℃, the blood pressure, high blood pressure, the lower the more (3) If the furnace temperature is equal to 600 ℃, then keep the voltage constant. Set of fuzzy controller for one-dimensional controller, input linguistic variables for error, the output control voltage. Input and output variables of quantization levels for seven, take five fuzzy sets, membership function test design error variance divided table, partition table and the control voltage variation fuzzy control rule table.)
    2015-04-10 21:53:18下载
    积分:1
  • doubleTTgratingn
    量子阱红外探测器用双周期衍射光栅,光栅图形,光强分布等用matlab程序(Quantum well infrared detectors using double period of the diffraction grating, grating pattern, the light intensity distribution program with matlab)
    2016-06-06 19:46:51下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载