isctest

采用极点配置的方法控制一级倒立摆系统，通过改变系统的参数，即增益系数K，最后使系统达到平衡。(Pole placement method using an inverted pendulum control system, by changing the system parameters, ie gain coefficient K, the last to make the system balanced.)

一个量化噪声分析程序。该代码是不长，只供参考。学生专用的试验。(One of the quantization noise analysis program. The code is not long for reference only. Students of special test.)

vuvujela denoising using matlab

Abstract The study of digital signal processing normally concentrates on the design, realization, and application of single-input, single-output digital filters. There are applications, as in the case of spectrum analyzer, where it is desired to separate a signal into a set of sub-band signals occupying, usually nonoverlapping, portions of the original frequency band. In other applications, it may be desired to combine many such sub-band

说明：  pq法的谐波检测，谐波源是三相全桥整流电路(Pq method of harmonic detection, harmonic source is a three-phase full-bridge rectifier circuit)

无线传感器经典算法，一种分层式的算法，有助于学习无线传感器。(Wireless sensor classical algorithm, a hierarchical algorithm, wireless sensor conducive to learning.)

rossler混沌系统图像，u取不同参数时的6种混沌状态(rossler chaotic system images, u for different parameters of the six Chaos)

matlab经典算法的程序，适合数学建模时使用(Matlab algorithm procedures, suitable for classical mathematical modeling when used)

matlab的初级教程，对初学者很有帮助，内容很全面，每个知识点附带有例子(Matlab of the primary curriculum, useful for beginners, the content is very comprehensive, each knowledge point with examples)

三相桥式全控整流电路的MATLAB仿真例程，可以通过改变触发角来控制负载输出的电压(MATLAB simulation routines fully controlled three-phase bridge rectifier circuit can be controlled by changing the firing angle load output voltage)