COOPERATIVE-MIMO

说明：  lms实现自适应均衡器 作用是比较明显的(lms)

FFT滤波matlab程序FFT滤波matlab程序(FFT filter)

利用matlab计算电压与电流相位差，定A相电压相位为0.(Matlab calculated using voltage and current phase, phase-phase voltage set A to 0.)

实现一维和二维分世界傅里叶变换，含有对LFM信号的实例仿真。(Realization of one and two dimensional Fourier transform divided world, contain instances of LFM signal simulation.)

中值滤波 降噪 可有效滤除高斯和椒盐噪声 保持图像边缘 (medfilt2)

用matlab实现qpsk，oqpk的调制解调，并计算误码率(Using matlab to achieve qpsk, oqpk of modulation and demodulation, and calculate the error rate)

这个文件是关于matlab曲线拟合的资料，对学习matlab曲线拟合非常有用(This document is about matlab curve fitting information, to learn matlab curve fitting is useful)

形态学的膨胀，腐蚀，细化的MATLAB的源代码，对初学者有用(Morphological expansion, corrosion, thinning of MATLAB source code, useful for beginners)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

用于检测提取特征点的可重复性代码，可重复性好则说明特征较好(for detection feature extraction point code of repeatability, reproducibility is better to describe characteristics)