Matlab-Face

采用的是通用的平面波展开法,汽车课设货车Matlab驱动力图程序，光纤陀螺输出误差的allan方差分析。( Using common plane wave expansion method, Car class-based truck driver trying to Matlab program, allan FOG output error variance analysis.)

对于惯性器件的标定进行自动处理,实现一次试验过程中完成对标度因素,安装角多个参数的标定(For calibration of inertial devices for automatic processing, once the testing process is completed on the scale factor, installation angle calibration of multiple parameters)

simulink下的异步交流异步电机dqo模型，可以模拟异步电机定子短路和转子断条的故障(asynchronous AC induction motor dqo under simulink model can simulate asynchronous motor stator and rotor off of a short circuit fault)

实现在60度坐标系下的三电平SVPWM的整流算法实现(Implementation of the three level SVPWM rectifier algorithm in the 60 degree coordinate system)

模拟了一个信噪比为10dB的边界层风廓线雷达的回波信号(To simulate a signal to noise ratio of 10dB boundary layer wind profiler radar echo signal)

说明：  tsoa是画椭圆模型的，利用多个椭圆进行定位，程序代码(Painted oval model, positioning)

achieving smallest MSE (in noise contamination)

产生一个连续信号，包含低频，中频，高频分量，对其进行采样，进行频谱分析，分别设计三种高通，低通，带通滤波器对信号进行滤波处理，观察滤波后信号的频谱。(generating a continue time singal,which contains low,middle and high frequences,sampling it.analisize its spetrum.Then designing three kind filters are lowpass,highpass,bandpass filters and processing it.Observing its spetrum.)

说明：  matlab数学建模的基础知识讲解，介绍MATLAB在概率统计中的若干命令和使用格式。(A Course of Mathematical Modelling)

说明：  最大类间方差法又称otus方法，是日本学者大津展之在最小二乘法原理基础上提出来的，其本质是一种阐值分割方法。 (Otsu method, also known as otus method, Otsu, Japan scholars in the development of the least squares method based on the principle put forward by its very nature is a kind of illustrates the value of segmentation.)