bresenham-line-algorithm.pdf

matlab仿真模型，非常全面的逆变器仿真模型，可以当作毕业设计内容使用。(matlab simulation model, a very comprehensive simulation model of the inverter can be used as a graduation project content.)

this is about digital modulation techniques used in matlab

逆变器用svpwm空间矢量脉宽调制程序详解，matlab仿真使用。(Inverters svpwm space vector pulse width modulation Detailed procedures, matlab simulation use.)

共轭梯度法matlab源程序 很好很强大 快来下载 快来啊(gongetidufa)

求解最小生成树的Matlab源程序，简单易懂。(Source file of Matlab to slove Minitree problem.)

SAD匹配，修改下文件路径即可用，matlab(SAD matching, can be used to modify the path)

哥伦比亚大学编写的MATLAB-HTK工具箱(Columbia University toolbox written in MATLAB-HTK)

对比分析lv-music和极化esprit算法q-music算法的估计性能(Comparison of lv-music and Polarization esprit algorithm q-music algorithm to estimate the performance)

TV 重建工具箱，用于处理图像的去噪，去模糊，修补等，是很好的学习工具。(TV rebuild Toolbox for denoising image to blur, repair, etc., is a good learning tool.)

说明：  根据前人研究成果可以证明，煤镜质组反射率各向异性对煤田构造特征具有指示意义，镜质组最小反射率可以指示构造主应力方向。然而，在实际测量中，如何得到真正的镜质组最大、最小反射率及其方位是其中的关键环节。利用现有的岩石有限应变椭球拟合方法进行镜质组反射率椭球体拟合不失为一种行之有效的方法，可以由此确定镜质组最大、最小、中间反射率及其三维空间方位。 将之前拟合得到的反射率椭圆看作岩石有限应变椭圆即二维应变，其由之前的统计方法测定得到，三个截面的数据对于拟合唯一应变椭球来说是过多的，因此不可避免出现误差，导致三个截面应变椭圆不通过同一个椭球的情况。为了从三个截面数据得到唯一的应变椭球，需要对得到的数据进行相容性调整。采用Oertel的方法，从每一测量参数在不同截面中的值是正态分布这一假定出发，利用加权最小二乘法进行误差调整。(According to results of previous studies may prove vitrinite reflectance anisotropy on structural characteristics have implications for coal, vitrinite reflectance may indicate tectonic minimum principal stress directions. However, in actual measurement, how to get real vitrinite maximum, minimum reflectivity and its orientation is the key link. Conduct vitrinite reflectance ellipsoid fitting regarded as a proven method using existing rock finite strain ellipsoid fitting method can thus determine vitrinite maximum, minimum, intermediate reflectance and dimensional spatial orientation . Before fitting the reflectance of finite strain ellipse oval rock that is seen as a two-dimensional strain, as determined by statistical methods which have been before the data fit only for the three sections of the strain ellipsoid is excessive, and therefore can not to avoid errors, resulting in three elliptical cross-section does not pass through the same strain ellipsoid situation. In order to obtai)