Tfreq_estimath

NSC program calculates BER of NSC

实现发动机性能的计算，在matlab环境下简单可靠的运行(this can use at matlab to engine)

光伏发电系统，电流电压输出曲线波形吐血土建(Photovoltaic systems, current and voltage waveform output curve vomiting civil)

关于MCGS锅炉控制的实验事例，供大家参考(the example about MCGS)

功率电子领域matlab仿真文件，已经验证过，程序运行正常(Power electronics field matlab simulation file, has already been verified, the normal operating procedures)

windows打开拍照检索关闭camera的相关函数实现(The camera Function for windows)

海量工业数据处理使用，包括了稳态测试，剔除坏值，计算标准差和平均值等(Massive use of industrial data processing, including the steady-state test, remove bad values, calculate the standard deviation and mean, etc.)

仿真程序：首先需要用一个随机发生器产生（0.1）内的均匀随机数，然后再将该序列映射到对应的幅度电平｛Am｝。然后将这个范围再分成4个相等的区间，这些子区间分别对应于4个信号比特的符号00，01，10，11。检测器观察到r=Am+n，并且计算r和4种可能传输的信号幅度之间的距离，它的输出Bm就是相应于最小距离的信号电平。Bm与真正的的传输信号幅度比较，差错计数器用来对检测器产生的差错计数。(Simulation program: first need to use a random generator (0.1) the uniform random number, then the sequence is mapped to the corresponding amplitude level {Am}. Then this range has been divided into four equal intervals, these sub-intervals corresponding to four signal bits of the symbol 00,01,10,11. Detector observed r = Am+ n, and calculate r and 4 possible transmission distance between the signal amplitude, its output corresponding to the minimum distance Bm is the signal level. Bm and the real rate of transmission of the signal comparison, error detection counter is used to generate the error count.)

backwardfoeward load flow for distribution network

ActiveMng.cpp MuOnline,DataServer,SourceCode for MuOnline DataServer (zTeam_24.10.13_S6_3)