MC9S08DZ60_CN_DEMO

对矩阵键盘的程序编写，详细地讲述了如何扫描键盘的输入！(The matrix keyboard programming, detailed tells the story of how to scan the keyboard input!)

说明：  设计一个VI来测量温度（保留2位小数），每隔0.25秒测一次，共测定10秒。在数据采集过程中，VI将在波形Chart上实时地显示测量结果。采集过程结束后，在Graph上画出温度数据曲线,并且把测量的温度值以文件的形式存盘， 使用记事本打开文件检查结果是否正确。 存盘格式为： 点数 时间(S) 温度值(度) 1 0.25 78.56 2 0.50 85.32(Design a VI to measure the temperature (keep two decimal places), measured once every 0.25 seconds, 10 seconds were measured. In the data collection process, VI will display the measurement results in real time on the waveform Chart. After the acquisition process, the temperature data in the Graph draw curves, and the temperature measured in the form of document archiving, Use Notepad to open the file to check the result is correct. Save format: Points Time (S) temperature (degrees) &nbsp 1 0.25 78.56 &nbsp 2 0.50 85.32)

BH1750+1602 STC89C52程序(BH1750+1602 STC89C52)

multisim电子仿真实验源文件(Multisim electronics simulation source files)

一个利用MSP430单片机采集NTC温度并在四位数码管上显示的程序，仿照Anduino内核格式，包含一位差值算法(A collection NTC temperature using the MSP430 microcontroller and four digital tube display program, modeled Anduino kernel formats, including a difference algorithm)

C51控制ADS1256通过串口显示，已调试通过(ADS1256 C51 control via the UART, debugging through)

基于正点原子stm32的频谱 a1读取ad信号显示(Punctuality atomic spectrum based stm32 a1 read signal display ad)

工业无线传感器网络wirelesshart的标准描述，官网收费，可以很好掌握wirelesshart的各层协议结构(wirelesshart procotol)

Toshiba s TMPM370 torque control specification

嵌入式中C51和A51函数互调，包括一些基本的介绍、规则、注意点。是嵌入式开发人员必须知晓的东东。不要错过奥！(C51 and A51 programs rules and examples.it helps you write, compile, and debug embedded programs.)