DBSCAN

单片机串口通信时波特率自适应程序，在avr单片机上测试效果不错。(Microcontroller serial communication baud rate, when adaptive procedure, avr microcontroller to test its effectiveness.)

以c51单片机为核心，利用1760芯片进行语音报时，51单片机控制(With c51 microcontroller core, the use of 1760 chip for voice timekeeping, 51 MCU control)

说明：  16点阵屏单片机程序，程序中有注说明，通俗易懂！(16 lattice screen SCM procedures, there is the process that is easily understood!)

采用TI LaunchPad开发板触摸屏控制DAC7611输出电压(TI LaunchPad development board using the touch screen controls DAC7611 output voltage)

多功能数字电表，能实现量程自动切换，液晶显示(Multi-function digital meter, to achieve automatic range switching, LCD)

参考ti提供得例子程序，先将他们得例子在自己得板子上跑起来，其实就是用自测试得方式来验证一下程序，也可以加些中断，看看程序怎么跑得。这步没问题得话，可以改写程序，当然还在自测试模式下先试，如果可以改写后，在自测试模式下可以。那么就差不多了，将自测试模式改成正常模式，将程序移植到自己得程序中，拿一个经过验证可以正常通讯得can模块通讯，记得两个can得速率要一致。当然这个can模块还要能让你看到或者说能验证你得can是否通讯正常。(Reference ti provide examples of procedures was, first they have to run up on the example of the board that she has, in fact, self-test was used to verify the program mode, you can also add some interruption to see how to run the program. This step was not a problem, you can rewrite the program, of course, still in test mode since the first try, if you can rewrite, can in self-test mode. Well almost, the self-test mode to normal mode, the program was ported to own program, get a proven module can communicate normally too can communicate, remember that two can get a rate to be consistent. Of course, this can also allow you to see the module or can verify whether you have can communicate properly.)

LCD显示18b20采集的温度，并且可以手动调整报警温度(LCD display 18b20 acquisition of temperature and can be adjusted manually alarm temperature)

说明：  主要介绍bldc（无刷直流电机）的本体设计以及控制方式(mainly introduce the design and control methods of bldc)

51单片机16*16点阵 使用指针显示汉字(Using pointer to display Chinese characters)

实现了tm4c1294的硬件i2c通信，很方便(The hardware I2C communication of tm4c1294 is realized)