nls5

电源技术实验设计程序实验2 升压控制 (The power technology experimental design program Experiment 2 boost control)

polar码编译码，采用SC译码，仿真可以成功(polar coding performed using SC decoding)

说明：  主要介绍了在Matlab中怎样仿真FIR滤波器组的设计(Describes how the simulation in Matlab, the design of FIR filter banks)

看过的最为清晰明了的ekf 源码，强烈推荐给初学者(Read the most clarity ekf source, highly recommended for beginners)

二极管钳位3电平换流器的参考例子，可以学习载波移相调制方式(NGP-3level inverter)

这个程序实现了ofdm下的注水原理，是一个基于速率的注水程序，并不是传统的基于功率的注水原理。(This program realise a program based on waterfilling method which is concerning the rate adaptation not the power adaptation.)

说明：  使用ADI方法解偏微分方程（二微加热器方程）(ADI method for the use of partial differential equations (2 micro-heater equation))

Compressive sensing SuOrEM code

可以实现MIMO波束的形成，可以实现MIMO波束的形成，可以实现MIMO波束的形成，可以实现MIMO波束的形成，可以实现MIMO波束的形成，可以实现MIMO波束的形成，(Beam forming MIMO can be realized,Beam forming MIMO can be realized,Beam forming MIMO can be realized,Beam forming MIMO can be realized,Beam forming MIMO can be realized,)

考虑雨衰 阴影 和多径影响，利用自然梯度算法，非归零型差分相位调制信号建模与仿真分析 ，能量熵的计算，借鉴了主成分分析算法（PCA），基于负熵最大的独立分量分析，包括最小二乘法、SVM、神经网络、1_k近邻法。( Consider shadow rain attenuation and multipath effects Use of natural gradient algorithm, NRZ type differential phase modulation signal modeling and simulation analysis, Energy entropy calculation, It draws on principal component analysis algorithm (PCA), Based on negative entropy largest independent component analysis, Including the least squares method, the SVM, neural networks, 1 _k neighbor method.)