Matlab-Functions

By using these matlab codes one can simulate awgn in any system and cam add it to any signal for further analysis

Harmony search algorithm . a method for optimization a nonlinear problems with constraints.

3、 瑞利信道中的调制解调、信道估计： (1) 请推导出单径瑞利信道中的BPSK相干解调的理论误码率性能，并画出比特信噪比与误码率的关系曲线。 (2) 在单径瑞利信道中，请设计一种时分的导引辅助的信道估计方法，用Simulink进行仿真，测量BPSK的误码率性能，画出比特信噪比与误码率的关系曲线，并与(1)的曲线进行对比。 (3, the Rayleigh channel modulation and demodulation, channel estimation: (1) Please derive the single-path Rayleigh channel coherent demodulation of BPSK BER performance theory, and draw the signal to noise ratio and bit error rate curves. (2) single-path Rayleigh channel, please design a division of the guide-assisted channel estimation method, using Simulink simulation, measurement of the BER performance of BPSK, draw-bit signal to noise ratio and bit error rate curve, and with (1) of the curves were compared. )

对录音信号集 中的某一语音，利用BATLAB设计一美尔例谱算法，并实现。 取信号集 中的一个语音信号：“xxxxxx”，将它作为输入的语音信号来为设计一个美尔倒谱算法，在该算法中，主要设计了以下环节： 1.读入一个语音信号；2.对这个信号归一化；3.对归一化的信号进行加窗处理（这里的矩形窗长度必须为257，重帧长64）；4.进行预加重处理，即通过一个高通滤波器： ；5进行512点的FFT；6.分别取模平方得到功率谱；7.在设计的mel滤波器组中，我采用了25个带通滤波器；8.将得到的功率谱信号通过mel滤波器组，得到相应的25个功率值；9.对这些功率值取自然对数；10.对这些值取离散作弦变换；11.将得到的值去掉直流分量，取其它值作为MFCC参数。 (Concentrated on recording a voice signal, using BATLAB designed Mayer cases spectral algorithm, and implementation. Get a voice signal signal focus: "xxxxxx", will it as input for the design of a voice signal to Mel Cepstrum algorithm in the algorithm, the main design of the following links: 1. Read a speech signal 2. On the signal normalized 3. Of the normalized windowed signal processing (here, rectangular window length must be 257, re-frame size 64) 4. For Pre-emphasis processing through a high-pass filter: 5 for 512 points of FFT 6. modulo square were obtained spectrum 7. in the design of mel filter banks, I use a 25 band-pass filter 8 . will be the power spectrum signal by mel filter bank, corresponding to the 25 power values 9. on the power to take the natural logarithm value 10. to take these values as strings of discrete transform 11. will be of value to out DC component, to take other values as MFCC parameters.)

说明：  最小费用最大流问题 MATLAB编程代码(Maximum flow problem minimum cost MATLAB programming code)

Get Transfer Fucntion of System using fminsearch

很好的资料换引发大家 的是发生地方的是发生地方的是发生地方的是发生地方(Information for a good cause is the place where everyone is the place where the occurrence took place is the place where)

3GPP SCM信道模型，根据TS25.996编写(3GPP SCM channel model)

最小二乘法算法：其中文件“RFrost.txt为信号(Least squares algorithm: one document " RFrost.txt for signal)

用matlab编写的猜数字有些，希望对大家有用。(Prepared using matlab numberguess some hope for all of us.)