NRF905

基于stm32的usb转can。有源码以及电路图。(Based on stm32 the usb transfer can. Source code and schematics.)

ARMSYS6410(V1.1),立宇泰6410开发板随板关盘里的资料，扩展板的原理图，我买的板子(ARMSYS6410 (V1.1), Li Yu-tai 6410 development board with the board off the data plate, expansion board schematics, I bought the board)

Micrium官方移植的uc-OS III到 stm32f746平台，值得参考与借鉴。(This software package is ported to stm32f746 platform by Micrium.)

balance code of a infix notification..this code balance the infix..try it

Including AHP, factor analysis, regression analysis, cluster analysis, Stepwise linear regression, Least-squares algorithm to fit a three-dimensional plane.

用STM32写的ADS8509的驱动,究竟调试完全通过。(Written with STM32 ADS8509 driver)

说明：  系统中采用了电压反馈闭环，单片机通过内部软件产生一路SPWM控制信号，然后经过逻辑门变换电路变换成逆变全桥所需的四路驱动信号，再经专用驱动芯片TLP250隔离放大后，分别加到逆变全桥四个IGBT的栅极，进行驱动控制。(The voltage feedback closed loop is used in the system, and the single chip microcomputer generates all the SPWM control signal through the internal software, then transforms the four-way drive signal required by the logic gate transformation circuit into the inverter full bridge, and then adds to the gate of four IGBT of the inverter full bridge after the special drive chip TLP250 isolation and amplification, and carries on the drive control.)

Link an LCD to ARM microcontroller (AT91SAM) and drive it. This is a library and can be used in any application written with Keil uVision.

基于STM32F103的M25P64的驱动程序(the driver of the M25P64 based on the STM32F103)

STM32f103vet6 _BMS_ SOC CODE