TC35

说明：  运用matlab实现8PSK信号的调制与解调(relization of modulation and demodulation of 8PSK signal by Matlab)

脉冲压缩的匹配滤波。目标距离分别为10米，30米和100米，对于未压缩的脉冲，三个回波信号混叠在一起，不能分辨，而经过脉冲压缩的脉冲信号则可通过匹配滤波收到3个回波信号(Matched filtering for pulse compression.Target distances are 10 metres, 30 metres and 100 metres, respectively. For uncompressed pulses,The three echo signals are overlapped and can not be distinguished. While pulse compression can distinguish three echo signals after matched filtering)

Turbo decoder for 3GPP2

QT环境下开发的，用于测试电力通讯规约IEC103的一个程序(QT development environment for the testing of electrical communications statute a procedure IEC103)

使用QT编写的一个串口升级工具，升级协议采用TI的LM3S系列的bootloader串口协议。(A serial upgrade tool, written using QT upgrade protocol using of TI' s LM3S series the bootloader serial port protocol.)

用MATLAB产生线性跳频信号，中心频率和带宽可调(Using MATLAB to generate linear frequency hopping signal with adjustable center frequency and bandwidth)

说明：  The whole reuse mode of LTE is simulated systematically, which is a good learning program.

电力最常用的规约的学习资料，包括101,102,103,104，modbus，cdt，其中104还有测试程序，及解析工具；( The most commonly used power statute learning materials, including 101,102,103,104, modbus, cdt, where there are 104 test procedures, and analysis tool )

相控阵天线综合，程序可以根据输入的阵列天线的参数，可以计算出所需天线的各单元激励信号。(Phased array antenna synthesis )

信息通过LDPC编解码误码率与未编码信息误码率比较(Comparison of BER between uncoded information and LDPC code)