LEDtest

超声波测距（5 28线性处理）,测量线性度很高(Ultrasonic Ranging (528 linear processing), high linearity measurements)

设计的电机驱动控制系统的主要功能有①控制电机的正转、反转；②为电机设计控制速度，有5m/s、10m/s、15m/s三个等级；③给电机设定转动的位移，让电机按照设定的位移移动；④1602液晶上显示电机的位移和速度；⑤利用4*4键盘数字输入控制电机的速度、按键C和D控制正反转、按键B控制三个档位的速度。(Using SCM software and hardware systems to achieve precision stage displacement, velocity through three or four phase stepper motors (motors meet the acceleration and deceleration characteristics), control the direction, location. Completion of the control circuit board hardware, including CPU, power amplifier, buttons, LED display. Software can be implemented in C.)

带参数子程序控制LED闪烁，适合单片机初学者(Subroutine with parameter control LED flashes, suitable for beginners SCM)

说明：  描述了AD9850、AD9851、AD9854、AD9833的调试心得(Describes the AD9850, AD9851, AD9854, AD9833 debugging experience)

用C8051F020实现正弦波的程序设计(Program designed to use the C8051F020 achieve sine wave)

本文介绍一种利用单片机本身所提供的串行通讯口，采用自定义串行通信协议，加上总线驱动器如MAX481、MAX483、MAX485、MAX487等组合成简单的RS－485通讯网络，完成单片机间的多机通讯。(This article describes a serial communication port provided by the microcontroller itself, the custom serial communication protocols, coupled with the bus driver, such as the MAX481, MAX483, MAX485, MAX487, combined into a simple RS-485 communication network, complete single-chip between themulti-machine communication. )

51单片机的学习，8*8点阵的有关程序编程(51 MCU learning, about 8* 8 dot matrix programming)

交通信号控制,适用于51单片机芯片上，运行环境为visual C(Traffic signal control, suitable for 51 MCU chip, the operating environment for the visual C)

对于单片机上的一些简单的开发程序和他们的应用(For some simple microcontroller development process and their application)

stm32芯片--用GPIO口模拟I2C驱动MPU6050陀螺仪(Stm32 chip- using GPIO port simulation I2C driver MPU6050 gyroscope)