Gnuplot.tar

这是国外的同行编写的画图板程序，感觉比陈建春的要好些，说实话研究了半天，发现国内的cad水平低不是因为国内的人笨，主要是国外的cad技术不能很快的传递到国人手中，总是参考陈建华等水平有限，工程水平差的书籍造成整体水平低，书中没有详细的流程图，和软件设计思路，而且代码错误连篇。(This is the foreign counterparts of the drawing board to prepare procedures, CHEN Jian-chun than feeling the need to better tell the truth for a long time study and found that low levels of domestic cad because people are not stupid, mainly abroad cad technology should not quickly delivered to the the hands of the people always refer to Chen Jianhua, such as the limited level, engineering level difference caused by the overall level of books low, the lack of a detailed flow chart of the book, and software design, and code errors pack.)

说明：  PSCAD线路故障仿真模型，可供初学者参考使用(PSCAD line fault simulation model can be used for reference by beginners.)

Buck环路补偿Mathcad计算范例，十分经典！(Loop compensation for Buck converter)

一个含光伏风电的小系统的pscad模型，是用PSCAD软件做的。(One containing the system pscad photovoltaic wind power model, is to do with the PSCAD software.)

这是一个模拟acdsee软件打开一幅bmp文件并显示在屏幕上的算法.(This is a simulation software Converter opened a bmp file and display on the screen of the algorithm.)

cad提取文字坐标 能提取文字所在点的坐标值并保存到text中 (cad text extraction coordinates coordinates of the text can be extracted and saved to the point where the text of the)

基于PACAD4.2搭建的双有源桥DC-DC变换器仿真模型，可实现基本的功能，可快速入门并可在此基础上进行进一步的学习等。(PACAD4.2 built based on the dual active bridge DC-DC converter simulation model, the basic functions can be achieved, can be quickly started, and on this basis for further study.)

自己编的可输入数据的，三次B样条曲线程序源码(nurbs spline)

本代码实现两段贝切尔曲线的拼接，这里会分别显示两段曲线，再显示拼接后的曲线。(The code implements the splicing of the two sections Bei Qieer curve, and here are two curves, and then display the mosaic curve.)

得到以电阻为参数的boost变换器的数据关联性分析(Data correlation analysis of boost converter with resistance as the parameter is obtained.)