-
STRUCTURAL-BREAKS-ESTIMATION
基于遗传算法的断点估计,对非平稳信号进行分段,使其分段平稳,便于对信号的处理,尤其对于语音信号,非常常用(Based on genetic algorithms breakpoint estimates for non-stationary signal segment, making it piecewise smooth, easy signal processing, especially for the speech signal, very common)
- 2013-04-17 13:54:09下载
- 积分:1
-
physicaloptics-
一束5W 的线偏振光以Φ = 45 度方位角振动,垂直入射到玻璃 - 空气表面,该光束波长0.6μm,玻璃介质折射率1.54 @0.6m,当入射角θ从0-70 度变化时,通过给定条件,分别完成如下要求:
画出该光束反射光的光强曲线(I-θ);
分析该反射光束的偏振态变化,画出偏振方向变化曲线(φ-θ)和偏振光束相位变化曲线
(Φ-θ)。
(注:光束从光密到光疏的界面,在入射角θ 从0-70 度变化中,包括了临界角θc)(Bunch of linearly polarized light 5W to Φ = 45 degrees azimuth vibration, normal incidence to the glass- air surface, the beam wavelength 0.6μm, glass refractive index 1.54 @ 0.6m, when the incident angle θ changes from 0-70 degrees By the given conditions, namely the completion of the following requirements: Draw the reflected light beam intensity curve (I-θ) analysis of changes in the polarization state of the reflected beam, draw the polarization direction of the curve (φ-θ) and polarized beam phase curve (Φ-θ). (Note: the light beam from the optical density of the interface is sparse, the incident angle θ variation from 0-70, including the critical angle θc))
- 2013-12-21 15:01:42下载
- 积分:1
-
doddcx
对偶单纯形法matlab的实现,是我的一个作业.看看好用不.(dual simplex method Matlab the realization of one of my operations. Not look at the handy.)
- 2007-03-09 09:36:55下载
- 积分:1
-
Simulink-Modeling-and-Simulation
针对初学者的simulink 的建模与仿真,详细讲述系统仿真原理(Simulink modeling and simulation for beginners, and a detailed account of the principles of system simulation)
- 2014-11-02 14:24:56下载
- 积分:1
-
4byte-charto-float
编程中出现的小程序,四字节char型数组转浮点数(four byte char to float)
- 2015-01-16 14:09:04下载
- 积分:1
-
matlab_DIP
< 数字图像处理》作者-姚敏中所有matlab源程序()
- 2007-07-10 18:33:21下载
- 积分:1
-
EFPI_os4
瑞士苏黎世理工四螺旋桨直升飞机的仿真程序,已经作为课程讲解,值得借鉴和学习!(Polytechnic in Zurich, Switzerland four propeller helicopter simulation program has been explained as a curriculum, it is worth drawing on and learning!)
- 2008-06-26 20:43:09下载
- 积分:1
-
ex1info
对输电线路进行完全分析和补偿,主要是输电线路的演示程序(On transmission lines are fully analyzed and compensation, mainly is the transmission line demo)
- 2010-03-11 10:34:18下载
- 积分:1
-
three_dim_plot
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:56:06下载
- 积分:1
-
TECH_MEMO-93-07
Longitudinal Control of the Lead Car of a Platoon
- 2021-03-02 15:09:34下载
- 积分:1