-
libogg-1.1.3
THIS FILE IS PART OF THE OggVorbis SOFTWARE CODEC SOURCE CODE.
- 2007-07-24 15:22:46下载
- 积分:1
-
svc
this is the simulation model of the two generator system with midpoint voltage compensation in the open loop using the fc-tcr with the firing of the scr in the open loop.
the midpoint voltage iss compensated and bring down to the nearly 1 p.u.
it is helpful to understand svc and also can be helpful to design in the closed loop control system for the compensataion...
Arvind
- 2010-03-13 17:38:33下载
- 积分:1
-
Pole-zero
系统的模型并求出零极点形式和部分分式形式(Pole-zero programming)
- 2013-03-08 21:38:05下载
- 积分:1
-
TOA-signal-sorting
一种基于空间到达角的卫星电子侦察信号分选方法,一种基于空间到达角的卫星电子侦察信号分选方法(Spatial angle of arrival based electronic reconnaissance satellite signal sorting method, a space-based electronic reconnaissance satellite angle of arrival signal sorting method)
- 2011-11-21 22:38:47下载
- 积分:1
-
Modern_Signal_Processing_MATLAB
胡光书的《现代数字信号处理》课后习题的答案~是课后习题不是例题啊(Hu book " Modern digital signal processing" after-school After-School Exercises answer ~ is not the Example ah Problem)
- 2010-01-07 15:18:01下载
- 积分:1
-
NAFSMFilter
详细解说了基于噪声自适应模糊选择滤波器的椒盐噪声抑制处理的原理和主要公式(Detailed explanation of the adaptive fuzzy selection filter based on noise and salt and pepper noise suppression processing principles and the main formula)
- 2012-07-01 15:22:52下载
- 积分:1
-
openfile1
一个用于实测信号处理处理与分析的实例,主要有时域分析和频域分析(A processing instance of the processing and analysis for the measured signal mainly sometimes domain analysis and frequency domain analysis)
- 2013-03-21 12:22:01下载
- 积分:1
-
06803080
LTE document IEEE paper very useful
- 2015-02-26 12:39:16下载
- 积分:1
-
trns
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:45:44下载
- 积分:1
-
zuobiaozhuanhuan
大地测量学原理坐标转换程序,能实现大地坐标到平面的互相转换(The geodetic coordinate conversion program principle, can realize the earth coordinate to plane conversion to each other
)
- 2012-05-01 12:11:11下载
- 积分:1