登录
首页 » matlab » Rician

Rician

于 2014-08-11 发布 文件大小:28KB
0 228
下载积分: 1 下载次数: 18

代码说明:

  设计了信息在空间传输的莱斯信号模型,当接收端存在一个主要的静态信号时,如LOS分量(如在郊区和农村等开阔区域中)等,此时接收端接收的信号的包络就服从Rician分布。(Rician signal model)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 123
    在matlab的环境下证明傅里叶切片定理(At the matlab environment Fourier slice theorem proved)
    2009-04-08 17:01:59下载
    积分:1
  • SONY_VISCA
    sony D70摄像机 visca端口定义(sony D70 visca port definition)
    2010-11-05 11:54:48下载
    积分:1
  • mimo0
    MULTIPLE INPUT MULTIPLE OUTPUT FOR WIRELESS COMMUNICATION
    2011-08-28 10:50:57下载
    积分:1
  • Microgrid-Wind-Turbine
    在Matlab中搭建的风力发电机最大功率控制系统模型 功率为10kw 可以用于风力发电微电网仿真(Build the model of maximum power control system of wind turbine In Matlab power of 10 kw wind power Can be used in micro grid simulation)
    2016-05-23 21:43:27下载
    积分:1
  • model
    说明:  建立simulink模型进行波图像的仿真分析(Establishing Simulink model to simulate and analyze wave image)
    2019-03-23 13:22:19下载
    积分:1
  • Monte-Carlo-algorithm
    蒙特卡罗算法 内含蒙特卡罗方法学习书籍+matlab实现源码(Monte Carlo algorithm)
    2021-01-14 11:38:47下载
    积分:1
  • pi_rp
    simulink模拟比例-积分控制器应用于重覆性控制(simulink simulation proportional- integral controller used in the repetitive control)
    2012-06-18 04:20:21下载
    积分:1
  • Tensor_MIMO
    这是CISS会议上发表的著名论文“Tensor Canonical decomposition based method for blind identification of MIMO system with 3-input 2-output case”的源程序,主要是讲基于张量规范分解的多天线系统的忙识别问题,里边包含了相应的文章,可以一起对照着看。(conference on the famous treatise "Tensor Canonical deco mposition based method for blind identificati on of MIMO system with 3-input 2-output case, "the source procedures, primarily based on stress tensor decomposition of standardized multiple antenna system to identify problems in the 1980s, contained inside a corresponding article, can work together to look to see.)
    2007-05-23 14:37:21下载
    积分:1
  • zonghe_try (1)
    对铅酸蓄电池,超级电容,锂电池,三者连接到dc-dc变换器升降压,然后采取不同的控制策略,恒压,恒流,恒功率控制,最后通过逆变器将直流变交流。matlab 仿真(For lead-acid batteries, supercapacitors and lithium batteries, the three are connected to the dc-dc converter to increase and decrease the voltage. Then, different control strategies are adopted to control the constant voltage, constant current and constant power. Finally, the dc converter is changed into an alternating current through the inverter.The matlab simulation)
    2018-10-24 10:34:39下载
    积分:1
  • xibaobianyuanjiance001
    细胞边缘检测,带测试图片,matlab实现,效果不错(Cell edge detection, with the test picture, matlab achieved good results)
    2007-11-22 16:26:39下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载