2

vc与matlab混合编程的具体实例。vc调用matlab的.m函数，经过编译之后转换为C++程序，实现进行混合编程。(vc mixed with Matlab programming specific examples. Vc call Matlab. M function, compiled after the conversion of C procedures, mixed programming.)

基于FFT平面相控阵天线方向图快速计算 (Figure quickly calculate FFT-based planar phased array antenna direction)

非线性方程组数值解法之拟牛顿法matlab程序代码(The numerical method for solving the nonlinear equations of the quasi-newton method of matlab program code)

Spread Spectrum Technique simply consumes spectrum in excess of the minimum spectrum necessary to send the data.

用MATLAB的GUI设计的一个计算器程序，可在次基础上形成更复杂的算法，并学习GUI的设计技巧！(Using MATLAB)

利用matlab来求解方程，包括13个程序例子和一个ppt(Using matlab to solve equations, including 13 program examples and a ppt)

The overall objective for LTE is to provide an extremely high performance radio-access technology that offers full vehicular speed mobility and that can readily coexist with HSPA and earlier networks. OFDM/OFDMA technology is introduced for the LTE downlink, supporting very high data rates of up to 300Mbps while Single-Carrier FDMA (SC-FDMA) is used in the uplink with data rates of 80Mbps possible. Additionally, LTE supports operation both in paired and unpaired spectrum (FDD and TDD) using channel bandwidths of approximately 1.4MHz up to 20MHz. The frequency domain scheduling can be done in OFDMA. One of the main challenges in OFDMA is the high peak-to-average radio of the transmitted signal, which requires linearity in the transmitter. The linear amplifiers have low efficiency therefore, OFDMA is not an optimized solution for a mobile uplink where the

NIDAQ Matlab code. This code is provide communicate Matlab program and NIDAQ device. 1000 samples per second makes .

基于matlab的GUI曲柄摇杆机构的运动仿真的源程序。结果是运动的界面，输入参数可以求出摇杆机构的加速度，角加速度，极位夹角，行程速比系数等。(GUI crank rocker mechanism movement simulation based on matlab source program. Result is movement of the interface, input parameters can be calculated rocker mechanism of acceleration, angular acceleration, ultimate position Angle and travel speed ratio coefficient, etc.)

Matlab code for adding noise to sinusoids and finding characteristics like pdfs ,cdf etc