stbc_2x2_cfo0

粒子滤波方法用于跟踪，很易看懂的程序，建议初学者下载学习(Particle filter for tracking, it is easy to understand the procedures recommended for beginners to learn to download)

uploaded the polar codes for cooperative relay networks and the same can be used for compression

曲线、曲线修改、坐标轴范围及坐标轴修改等源代码(Curve, the curve changes to the scope and coordinate axis coordinate axis modify the source code, etc.)

Cut detection algorithm, uses histogram comparisonmethod.I ve also added a set of images.

里面有三个二维模糊调节器分别实现PID控制器的参数Kp，ki，Kd，的调节。其控制原理：根据前面的偏差e和偏差变化ec将三个模糊控制器FC1,FC2,FC3分别进行模糊化，模糊逻辑推理，解模糊化。最后得到pid控制器参数调节量。(There are three-dimensional fuzzy regulator PID controller parameters Kp, ki Kd, adjust. The control principle: the front of the deviation e and error change ec three fuzzy controllers FC1 has FC2, FC3, fuzzification, fuzzy logic inference, defuzzification. Finally, get the pid controller parameter adjustment.)

交流永磁同步电机矢量控制模型，仿真效果好，可供学习电机的同行参考。(AC permanent magnet synchronous motor vector control model, simulation results, and for learning motor peer reference.)

This simulation demonstrates the starting of a DC motor with automatic starter (5 hp 240V 1200 rpm) rated torque Tr = 30 N.m The starter is simulated by a speed-dependent effective armature resistance using a look-up table

1 本程序通过Mallat算法实现小波变换 2 本程序能打开任意长宽比的bmp图像，正方形的raw图像(Through a process of wavelet transform Mallat Algorithm 2 the procedure to open the bmp images of arbitrary aspect ratio, the square of the raw image)

捷联惯导仿真，对于初学捷联惯导的人有很大的帮助(SINS simulation SINS for the beginner who has a lot of help)

潮流计算的MATLAB源程序 简单潮流计算的牛顿拉夫逊程序，相关的原始数据数据数据输入格式如下： B1是支路参数矩阵，第一列和第二列是节点编号。节点编号由小到大编写 对于含有变压器的支路，第一列为低压侧节点编号，第二列为高压侧节点 编号，将变压器的串联阻抗置于低压侧处理。 第三列为支路的串列阻抗参数。 第四列为支路的对地导纳参数。 第五烈为含变压器支路的变压器的变比 第六列为变压器是否是否含有变压器的参数，其中“1”为含有变压器， “0”为不含有变压器。 B2为节点参数矩阵，其中第一列为节点注入发电功率参数；第二列为节点 负荷功率参数；第三列为节点电压参数；第六列为节点类型参数，其中 “1”为平衡节点，“2”为PQ节点，“3”为PV节点参数。 (MATLAB source of power flow calculation)