Research-on-Optimal-Coverage-Problem-of-Wireless-

说明：  S7200 通过modbus 通讯与多块表通讯 定时轮询(Reading multi block instrument timing polling)

Smoothing Filter-based Intensity Modulation a spectral preserve

详细介绍了西门子PLC的间接寻址方法，对于应用西门子PLC很有用处。(Detailed the the Siemens PLC indirect addressing method is useful for the application of the Siemens PLC.)

利用matlab GUI实现的串口编程例子，独立成分分析算法降低原始数据噪声，构成不同频率的调制信号。( Use serial programming examples matlab GUI implementation, Independent component analysis algorithm reduces the raw data noise, Constituting the modulated signals of different frequencies.)

人工神经网络的工具想函数一览表，可以查询很方便的(artificial neural network tool to the list of functions that can be very convenient inquiry)

在TOA测距的基础上，提出了一种三维无线传感器网络节点定位算法，并对其性能进行了分析，给出了算法的时间同步误差和定位误差。最后在现有仿真平台OMNET++的基础上构建三维仿真模块，对算法进行了仿真实现，给出了该算法的定位精度和覆盖率(This paper proposes one three-dimensional localization algorithm based on TOA distance measurement and analyzed the performance of the algorithm calculated time synchronization error and localization error. Finally it constructed three-dimensional simulation modules based on OMNET++ and implemented the algorithm educed the localization precision and coverage.)

支持IEC60870-5-104: 2000 IEC104规约软件包 实现104规约主站侧链路层的功能(IEC_Master_104.lib: void Init_SockServerport(WORD port=2404) void Init_Linkpara(int t0=30,int t1=15,int t2=10,int t3=20,int k=12,int w=8) virtual void On_init_Link_process() virtual void On_init_Sock_process() virtual void On_ErrorMsg(char*msgbuf) void slave_start() void slave_close() )

采用加权网络中节点强度和权重都是幂率分布的模型，双向PCS控制仿真，包含光伏电池模块、MPPT模块、BOOST模块、逆变模块。( Using weighted model nodes in the network strength and weight are power law distribution, Two-way PCS control simulation, PV modules contain, MPPT module, BOOST module, inverter module.)

TO PLOT THE RAYLEIGH DISTRIBUTION PLOT

说明：  针对数字卫星常用的 7 种通信信号调制方式(QPSK、8PSK、16QAM、32QAM、64QAM、16APSK、32APSK)，对零中心归一化瞬时幅度谱密度最大值、四次方谱、幅度、高阶累积量四种特征参数进行了分析，提出了一种联合特征参数的信号调制识别方法．(Aiming at seven communication signal modulation modes commonly used in digital satellite (QPSK, 8PSK, 16QAM, 32QAM, 64QAM, 16APSK and 32APSK), four characteristic parameters of zero-center normalized instantaneous amplitude spectral density, quadratic spectrum, amplitude and high-order cumulant are analyzed, and a signal modulation recognition method of joint characteristic parameters is proposed. Method.)