scriptofdmtx

实现基于STBC的MIMO_OFDM通信系统在不同信噪比情况下接收端的误比特率的仿真。发射端包括基于基带调制、空时编码、导频插入、IFFT、串并合并以及添加循环前缀；接收端包括去除循环前缀、取出导频估计信道、FFT运算以及并串合并，空时解码等。仿真中采用QPSK、空时编码采用4*3的复正交空时编码矩阵。OFDM子载波数为100，每个子载波传输66个符号，每个符号2比特。IFFT长度为512个符号。发射天线为3个接收天线为2个。(The BER simulation of MIMO_OFDM communication system based on STBC under different SNR is realized. The transmitter includes baseband modulation, space-time coding, pilot insertion, IFFT, serial-parallel combination and adding cyclic prefix; the receiver includes removing cyclic prefix, extracting pilot estimation channel, FFT operation, parallel-serial combination, space-time decoding, etc. The complex orthogonal space-time coding matrix is used in QPSK and space time coding in 4*3. The number of OFDM subcarriers is 100, and each subcarrier transfers 66 symbols with 2 bits per symbol. IFFT is 512 symbols in length. The transmitting antenna is 3 receiving antennas, 2.)

This thesis presents simulation data on array operation in wideband communication systems. It is shown that array structures with closer inter-element spacing outperform structures with much larger inter-element spacing. It is also shown that circular structures outperform linear structures. This performance dierence between the classications of arrays is due largely to the circular array s ability to handle high levels of interference. Even though a diversity combining scheme (MRC) was used in the simulator, the arrays provided interference rejection capabilities due to the closely spaced antenna elements.

实现了LDPC码的编码 LDPC译码、LDPC校验矩阵的生成等。是完整的LDPC代码。测试了，跑的通。自学LDPC码的资料(Implements the LDPC encoding of LDPC decoding, LDPC check matrix generation and so on. LDPC code is complete. Tested and run through. Self-study of LDPC codes)

微机之间串口通信,实现两台微型计算机之间快速简便的串行通信,()

dynamips的实际使用方法，很全面喔(the dynamips actual use, very comprehensive!)

弯管机PLC程序，可以参考学习，结合自己使用的实际情况改设置就可使用。(The bending machine PLC program, you can refer to learning, combined with the actual situation of their use changed settings can be used.)

用MSCOMM控件控制FXPLC全部输出/全部关闭/单独输出(MSCOMM control with full output control FXPLC/All off/single output)

Dynamic Subchannel and Bit Allocation in multiuser mimo-ofdma systems.

设计了差分编码移相键控(2DPSK)调制解调系统的工作流程图,并利用 Matlab 软件对该系统的动态进行了模拟仿真。利用仿真的结果,从基带信号的波形图可以衡量数字信号的传输质量 由系统的输入和输出波形图可以看出,仿真实验良好 。(Design of a differential phase shift keying encoding (2DPSK) modulation and demodulation system working flow chart of the system using Matlab software to simulate the dynamics simulation. Using simulation results, from the baseband signal waveform can be measured digital signal transmission quality by the system' s input and output waveforms can be seen that simulation is good.)

说明：  运用近似熵算法对cpm信号进行调制识别，然后计算识别率。(The approximate entropy algorithm is used to recognize the modulation of CPM signal, and then the recognition rate is calculated.)