登录
首页 » matlab » stop-and-wait-arq

stop-and-wait-arq

于 2011-08-03 发布 文件大小:8KB
0 223
下载积分: 1 下载次数: 52

代码说明:

  Stop-and-wait ARQ is a method used in telecommunications to send information between two connected devices. It ensures that information is not lost due to dropped packets and that packets are received in the correct order. It is the simplest kind of automatic repeat-request (ARQ) method. A stop-and-wait ARQ sender sends one frame at a time it is a special case of the general sliding window protocol with both transmit and receive window sizes equal to 1. After sending each frame, the sender doesn t send any further frames until it receives an acknowledgement (ACK) signal. After receiving a good frame, the receiver sends an ACK. If the ACK does not reach the sender before a certain time, known as the timeout, the sender sends the same frame again.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • SoundCard_Acquiring
    声卡采集的程序,可设置采样频率,位长,采样时间等参数.可采样8k-44.1kHz的信号,进行频谱分析.(sound card collection procedures, sampling frequency can be set up, elderly, Sampling time parameters. 8 k can be sampled- 44.1kHz signal spectrum analysis.)
    2007-07-05 21:00:02下载
    积分:1
  • GMSK
    为了提高移动通信系统中数据传输的有效性能,降低GMSK调制系统的误码率. 首先对GMSK调制系统进行分析,得到不同BT值GMSK调制的移动通信系统误码率和带宽的关系.通过引入具有纠错性能的编码技术,降低信息传输的误码率,提高系统的有效性. 本文给出了引入编码技术的GMSK调制系统的仿真模型,仿真结果表明,在相同的信噪比下,系统的误码率降低了1~2dB.(This paper mainly intends to improve the performance of the communication system and decrease the error bit rate of the information. First , the GMSKmodulation system was analyzed , and the relation of the BER and bandwidth in the different BT value was obtained. By introducing the encoding technology , the error bit rate of the information was lowered so that the performance of systemwas improved. This paper presents a simulated model . The results show that the BER of the system in the same SNR can lower 1 to 2 dB.)
    2010-05-16 21:43:28下载
    积分:1
  • fwdmatlabprogram
    this is the matlab program for amplify and forward
    2013-02-12 19:24:55下载
    积分:1
  • losseless_run_length_coder_decoder
    Lossy Run Length coding and decoding
    2009-09-16 19:53:58下载
    积分:1
  • M5-Files
    有限单元集成刚度程序,用于计算常见单元刚度矩阵及集成。(beamassemble .ect.)
    2010-07-23 16:52:11下载
    积分:1
  • MdoernSignalProcess
    包含了多个信号处理的算法,多通道滤波器,小波变换等信号处理的算法(filters, wavelets)
    2009-10-17 16:39:25下载
    积分:1
  • simsim
    minimizer of in-line coded functions
    2010-12-16 19:12:27下载
    积分:1
  • nonPAST
    采用非线性主分量方法对育信号进行分离的算法。运行环境MATLABR2008B。程序+报告都在里面(Nonlinear principal component method of fertility signal separation algorithms. Operating environment MATLABR2008B. Procedure+ reports inside)
    2009-06-16 09:33:15下载
    积分:1
  • add_phase_noise
    怎样给信号添加相位噪声--------------。(How to add phase noise to the signal.)
    2013-04-16 21:23:31下载
    积分:1
  • qam16
    利用MATLAB语言实现8QAM,16QAM等数字调制技术的调制过程仿真代码(MATLAB language 8QAM 16QAM digital modulation techniques modulation process simulation code)
    2013-05-01 19:45:26下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载