m4-16-64k20ber

Matlab code for COST207 channel

利用文中命令码，可以在ANSYS中实现如何输入地震波，这对结构动力分析非常重要！(Using text command code, can be implemented in ANSYS how to input seismic wave, which is very important for structural dynamic analysis!)

Mechanical vibrations exercises.

Extended Luenberger observer for speed-sensorless AC motor d

说明：  光伏并网模型，可实现光伏逆变器并网仿真模拟，获取仿真波形，可用于故障分析等(Photovoltaic grid-connected model can realize grid-connected photovoltaic inverter simulation, obtain simulation waveform, can be used for fault analysis)

统一设定带宽、脉宽、采样率、脉冲重复频率，用Matab产生16个脉冲的LFM，每个脉冲有4个目标（低速，静止，高速，低速），第3个目标的距离、速度与学号有关。前3个目标的幅度相同，第四个目标幅度是前三个的一半。且距离与第2个静止目标相同。 依次做如下处理： 1 脉压 2 脉压后，相邻2脉冲做MTI（即相邻2个脉冲对应相减），产生15个脉冲 3 脉压后，16个脉冲到齐后，做MTD，输出16个多普勒通道 4 对MTD结果做CFAR（恒虚警） (Unified set bandwidth, pulse width, sampling rate, pulse repetition frequency, and produces 16 pulses Matab LFM, with four goals each pulse (low-speed, static, high-speed, low speed), the first three goals of distance, speed and Student ID related. The first three goals of the same magnitude, and the fourth target range is half of the first three. And from the stationary target with the first two the same. Followed by treatment as follows: 1 pulse 2 pulse pressure, the adjacent two pulses do MTI (that is adjacent to two pulses corresponding to the subtraction), resulting in 15 pulse 3 pulse pressure, 16 pulses in attendance after doing MTD, 16 Doppler channel output 4 MTD results do CFAR (CFAR))

Vsfm to Matlab by Bashar Alsadik 05 Feb 2014 Vsfm to Matlab

递推算法与最小二乘具有相同的结构，但基本原理不同(Recursive algorithm has the same structure as least square, but the basic principle is different.)

It presents the simple full wave rectifier that is center tapped and a free wheeling diode is used for inductive load. Best for beginners

无线传感器网络的SEP、LEACH、HEED代码集合(Wireless sensor networks SEP, LEACH, HEED code set)