登录
首页 » matlab » gelei_Untitled

gelei_Untitled

于 2021-02-20 发布 文件大小:1KB
0 253
下载积分: 1 下载次数: 27

代码说明:

  降低PAPR编码方法中的格雷码仿真程序,能仿真出结果。仿真参数为:子载波数目N=16,BPSK调制,过采样因子w=16,(Reduce the PAPR coding method of Gray code emulator, simulation results. The simulation parameters: number of subcarriers N = 16, BPSK modulation over-sampling factor w = 16,)

文件列表:

gelei_Untitled.m,1899,2012-06-06

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 320338633PEG
    LDPC的矩阵生成,准循环码矩阵的生成,采用PEG算法生成,使用块矩阵方法(produce QC-LDPC matrix)
    2020-07-08 11:48:57下载
    积分:1
  • TCPIP-3
    TCPIP协议详解卷三:事务TCPIP协议详解卷三:事务TCPIP协议详解卷三:事务(TCPIP protocol Xiangjie Makizo: Services TCPIP protocol Xiangjie Makizo: Services TCPIP protocol Xiangjie Makizo: Services)
    2010-03-13 20:33:45下载
    积分:1
  • I-rife
    频率估计,是一种比较简单的算法,很基础,有助于初学者应用(Frequency estimation, is a relatively simple algorithm, it is based applications to help beginners )
    2011-10-31 09:32:16下载
    积分:1
  • NICControlClass
    枚举所有网卡、获取设置网卡参数、检查网卡状态、启禁网卡(Enum all NICs,get NIC paramates,check NIC state,enable/disable nic)
    2010-10-13 12:35:40下载
    积分:1
  • Verilog
    基于FPGA的16QAM调制解调设计,以及仿真实现(Design of 16QAM Modulation and Demodulation Based on FPGA)
    2021-02-19 16:29:44下载
    积分:1
  • MIMO-OFDM--SLM
    MIMO-OFDM降低PAPR的SLM算法(MIMO-OFDM algorithms reduce the PAPR of the SLM)
    2011-05-11 17:48:03下载
    积分:1
  • MIMO-OFDM Code
    说明:  MIMO-OFDM仿真,包含Jakes模型生成信道、信道编码、ZC序列生成和OFDM四个子文件(Simulation of MIMO-OFDM)
    2020-03-10 00:51:20下载
    积分:1
  • gps
    这是一套GPS定位采集程序,可用于卫星天线乏味俯仰角的计算(This is a set of GPS positioning acquisition procedures can be used for satellite antenna pitch angle tedious calculation)
    2009-05-06 22:43:03下载
    积分:1
  • hilbert
    说明:  产生正弦信号时域波形及频谱,并通过希尔伯特滤波器。其中希尔伯特滤波器有两种产生方式,一是使用MATLAB自带的FDAtool;二是程序编写。(The time-domain waveform and spectrum of sinusoidal signal are generated and passed through Hilbert filter. There are two ways to generate Hilbert filter, one is to use FDAtool in MATLAB, the other is to write programs.)
    2019-01-09 15:16:42下载
    积分:1
  • con cam
    通过labview与康耐视相机的In-sight软件通讯,通过tcp/ip,可发送指令(In-sight communication software, through the LabVIEW and Cognex camera through tcp/ip, send commands)
    2018-03-20 10:53:03下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载