111

说明：  该库函数用于驱动L293D模块，电机的前进后退等代码封装在里面面(The library function is used to drive L293D module.)

说明：  使用微控制器精确计数1SControl T0定时器计数器控制LED闪烁(Use the microcontroller to accurately count 1SControl T0 timer counterControl LED flashes)

51单片机中的LCD12864显示,用的是C语言，为KEIL程序包。(51 microcontroller in LCD12864 display)

binary reading implementation

FAT的C语言原代码,没有底层驱动,支持打开文件,读写文件,不支持长文件名.(FAT C language source code, there is no bottom-driven support to open the document, read and write documents, do not support long file names.)

STM32奋斗板步进电机测试,演示的是通过C口的4个口线利用tim2定时器，固定周期产生4路的脉冲信号模拟步进电机的4相8拍控制组合。步进电机采用型号为5V 28BYJ-48的步进减速电机。步进角 5.625度/64驱动板采用ULN2003驱动板。(STM32 struggle board stepper motor testing, demonstration by four port line C port utilization tim2 timer, fixed cycle 4 pulse signal generating analog 4-phase stepper motor control 8-beat combination. Stepper motor with model 5V 28BYJ-48 stepper gearmotors. 5.625 ° step angle/64 driver board with ULN2003 driver board.)

stm32f103系列单片机接，esp8266 wifi模块实现远程控制继电器。(Realization of remote control relay)

单片机实验中的键盘扫描实验，用lcd1602液晶显示屏显示按键值，c语言编写(for 51)

这是FreeRTOS移植到STM32F0系列单片机的实例，已经验证成功，成功的驱动了LED,24L01,SPI,ADC等等外设。源码已经测试通过无误。(This is FreeRTOS transplanted to STM32F0 MCU instance, has been verified successfully, the success of driven LED, 24L01, SPI, ADC and so on peripherals. Source code has been tested correctly.)

Fujitsu_Easy_Kit试用手记_从入门到精通(Fujitsu_Easy_Kit trial notes _ from entry to the master)