single_carrier_FD_equalization

tdoa定位的chan算法，其中进行了2次WLS计算(tdoa positioning chan algorithm, which carried out two times WLS computing)

基于MATLAB的维纳滤波器设计程序，滤除噪声得到原始信号(Wiener)

Geometry of Dynamical Systems

模糊逻辑控制仿真源代码,希望对大家有帮助(fuzzy logic cntrol Matlab simulation source code)

谱分析子空间MUSIC算法的实现以及MUSIC与直接估计的比较(Spectral analysis of subspace MUSIC MUSIC algorithm implementation and comparison with direct estimates)

设计一个IIR数字低通滤波器， 逼近一组模拟滤波器的指标参数（通带截止频率Wp=2*pi*2000rad/s,阻带边界频率Ws=2*pi*3000rad/s,通带波纹 Rp=3db, 阻带衰减Rs=15db, 采样频率f=10000Hz）； 分别用脉冲响应不变法和双线性变换法实现设计，列出传递函数并描绘模拟和数字滤波器的幅频和相频响应曲线。用上述设计滤波器完成几组给定信号的滤波，证明滤波器的有效性和滤波范围限制.(Design a IIR digital low-pass filter, approaching a group of analog filters indicator parameters (pass-band cut-off frequency Wp = 2* pi* 2000rad/s, stop-band edge frequency Ws = 2* pi* 3000rad/s, pass-band ripple Rp = 3db, stop-band attenuation Rs = 15db, the sampling frequency f = 10000Hz) were used to change the impulse response method and bilinear transformation method for design, list and describe the transfer function of analog and digital filter amplitude-frequency and phase-frequency response curve. A filter was designed with the completion of the above-mentioned groups of a given signal filtering, to prove the effectiveness of filters and filter limit)

Antoine equation from thermodynamic applications in chemicl engineering

说明：  时滞依赖不确定系统的保性能控制，发表于IEE控制理论(Uncertain systems with delay-dependent guaranteed cost control, published in the IEE Control Theory)

二进制转换十六进制的小程序，在控制台程序下编译成功，开发环境Visual studio 2013(Sixteen hexadecimal conversion binary)

变采样和多相滤波器的实现。本程序实现了一个变采样程序，中间设计滤波器设计和插值抽取。其中滤波器设计用的是窗函数法，根据要求设计窗函数，得到窗函数的长度。接着是插值，滤波，抽取，得到最后变采样之后的波形文件、另外对比了用直接卷积和多相分解卷积两种方法最后的结果。 (Implementation of variable sampling and polyphase filter. This procedure implements a variable sampling procedures, intermediate design and interpolation and decimation filter design. The filter design is using the window function method, according to the requirements of the design of window function, get the length of the window function. Then the interpolation, filtering, extraction, and finally obtain the variable wave file, sampling after the addition of contrast and polyphase decomposition results of two methods for convolution last direct convolution.)