登录
首页 » PDF » labview-xiaoboyuzhichuli

labview-xiaoboyuzhichuli

于 2007-05-18 发布 文件大小:78KB
0 271
下载积分: 1 下载次数: 139

代码说明:

  这篇文章主要介绍了利用LabVIEW软件进行小波处理的方法,希望给与大家参考(This article introduces the use of LabVIEW software wavelet processing method, wish to give your reference)

文件列表:

xiaoboquzao.kdh

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • vvvvA-Simple-Transmit-Diversity-Technique-in-wire
    This paper presents a simple two-branch transmit diversity scheme. Using two transmit antennas and one receive antenna the scheme provides the same diversity order as maximal-ratio receiver combining (MRRC) with one transmit antenna, and two receive antennas
    2014-05-15 15:13:15下载
    积分:1
  • PAPER6
    基于压缩感知的超宽带信道估计方法的研究.PDF(Research on CS-based Channel Estimation Methods for UWB Communications)
    2012-12-29 00:20:06下载
    积分:1
  • 5461
    说明:  故障检测,火车故障检测系统,labview实现(Fault detection, train fault detection system, LabVIEW implementation)
    2020-06-20 18:40:28下载
    积分:1
  • 5-fulltext
    Paper on using SDR for cognitive radio sensing performance metrics.
    2012-11-03 23:25:25下载
    积分:1
  • 895643
    These papers are very good review in renewable energy especially in solar energy, a must have for researchers!
    2015-05-17 15:29:37下载
    积分:1
  • 30professionalpapersonthe3DGIS
    说明:  30篇余有关三维GIS专业期刊论文,都是三维GIS开发和应用的期刊(30 professional papers on the 3DGIS)
    2009-07-23 23:31:27下载
    积分:1
  • visa
    VISA module 2 for serial communication
    2015-12-16 02:53:35下载
    积分:1
  • 134line-ver1.2
    LABVIEW 与欧姆龙PLC 基于OPC 的TOOLBUS通信程序(LABVIEW TO PLC)
    2015-10-12 11:41:03下载
    积分:1
  • 基于LabVIEW的通用自动测试系统设计
    基于LabvIEw的通用自动测试系统(ATs)舍计算机,可鳊程激励、响应数据采集及uuT模块,采用MxI总线控制方式。专用信号发生器为uuT提供模拟激励信号,矩阵开关和适配器完成不同信号间切换。主控计算机执行测试程序,信号发生器发送激励信号,数据采集卡采集数据,采集数据经调理后,并与标准数据|匕较是否满足相应测试结果。(The general automatic test system (ATs) based on LabvIEw can be used as a computer to excite, respond to data acquisition and uuT module. The control mode of MxI bus is adopted. Special signal generator provides analog excitation signal for uuT, matrix switch and adapter complete switching between different signals. The main control computer executes the test program, the signal generator sends the excitation signal, the data acquisition card collects the data, after the data acquisition is adjusted, and compares with the standard data | dagger whether it meets the corresponding test results.)
    2020-10-24 12:27:23下载
    积分:1
  • Error-Correct-Coding
    关于纠错码的很好的书籍。讲述了各种纠错码的原理(The error correcting code of good books. About the principle of a variety of error-correcting code)
    2020-12-09 13:39:19下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载