mh

1.原始信号A，通过信道受噪声污染后的信号q，然后分别经过均衡器ZF（MMSE）得到信号U，可以画出U的分布图 2.分别应用LMS,SATO,CMA算法得到U。（其中包括最佳延迟、均方误差的计算）所有结果均以图像形式显示。(1. The original signal A, subject to noise pollution through the channel after the signal q, and then through the equalizer, respectively ZF (MMSE) receive the signal U, the distribution of U can draw Figure 2. Were applied LMS, SATO, CMA algorithm to be U. (Including the best delay, mean square error terms) all the results are displayed in graphic form.)

用matlab实现了支持向量回归，并且使用了核函数，对于各种维度的数据均可使用(Using matlab to achieve an SVR, and uses kernel functions for the various dimensions of the data can be used)

QAM载波跟踪程序，用matlab写的，小程序，很实用，可以看看(QAM carrier recovery)

RBF方法求解泊松方程（二维）实例，选用RBF函数为MQ函数，采用配点法求解。(RBF method for solving two dimentional Poisson equation)

说明：  对线路中的快速暂态过电压进行建模仿真，能够详细的对过电压模型进行仿真(Modeling and simulation of fast transient overvoltages in the line, enabling detailed simulation of overvoltage models)

正弦波频率估计的经典文章，ieee的89年Steven Kay写的。(Sinusoidal frequency estimation of the classic article, ieee 89 years Steven Kay wrote.)

这是一个用Matlab编写的算术编码算法实现，输入编码序列，编码序列中各字符及其的出现次数。(arithmetic coder and decoder by Matlab)

convert Ply format Objects to triangulation mesh surface

很实用的一个OFDM仿真程序，OFDM采用BPSK、QPSK、16QAM、64QAM4种调制方式。按照星座图，将每个子信道上的数据，映射到星座图点的复数表示，转换为同相Ich和正交分量Qch。(A very practical OFDM simulation program, OFDM the BPSK, QPSK, 16 qam, 64 qam4 kind of modulation method. According to the constellation diagram, each will be the data on the channel, the plural of constellation is mapped to a point, said into in-phase Ich and quadrature Qch. )

采用PSO算法优化PID参数，通过调用simulink和PSO使得ITAE标准最小化(PID parameter optimization using PSO algorithm)