MDP

OFDM 16QAM Simulink model

说明：  采用开路电压法和安时积分法相结合的算法，对soc进行估计(open voltage circuit combined with columb counting method)

matlb code for DSP and its very importanay yo us to use it 2shta ya man

该代码为基于PID神经网络的系统控制算法(The code is a system control algorithm based on PID neural network)

阵列信号处理波束形成算法，MATLAB环境下编译通过，可直接应用或移植。(Array signal processing beamforming algorithm, compiled in MATLAB environment, can be directly applied or transplanted.)

载波频率不同的多个DSB信号混合后，在不知道源信号的情况下，将混合后的DSB信号分离出来(A different carrier frequency signals of multiple DSB after mixing the source signals without knowing the circumstances, would be a mixture of the DSB signal separation)

在瑞利衰落和高斯白噪声下dpsk调制对于不同信噪比的误码率(bit error rate of the dpsk modulation in Rayleigh fading and Gaussian white noise for different signal to noise ratio)

结构分析的有限元法与matlab程序设计3-1(Structural analysis of the finite element method and matlab programming 3-1)

在Matlab的Simulink仿真环境，使用电导增量法模拟MPPT模型仿真。(Matlab Simulink simulation environment, using simulation the incremental conductance Law analog MPPT model.)

用MATLAB编写的青花瓷。。。。。。。。。(Matlab matlabsd af)