xitongzuiyou

遗传算法和神经网络混合编程，可用于优化计算，仅供参考(Genetic algorithm and neural network hybrid programming, can be used to optimize the calculation, for reference only)

关于MATLAB编程用两种方法模拟光学实验(MATLAB programming on the optics experiments using two kinds of simulation)

使用matlab的语言编写的三电平SVPWM仿真程序，在simulink平台下使用(Use the matlab language of three-level SVPWM simulation program, used in simulink platform)

自己做的中频感应加热电源的simulink模型，其中调功部分采用buck电路，负载采用RLC串联谐振。(This is a mdl file of matlab,it shows the work of our team of a project of a power suply.)

说明：  matlab xfem 插件，可用于计算多裂纹交叉融并结果(Matlab XFEM plug-in can be used to calculate the results of multi crack cross fusion)

Bayes Decision Procedure Bases on MATLAB Progame

说明：  里面有滑模控制教材的所有程序,很有参考价值(Sliding mode control materials inside all of the programs)

matlab数学建模算法的书籍，可以当做简易手册使用，具体的算法实现还是得翻阅具体文献(as a handbook of algorithm with matlab)

说明：  基于股票分析方法的电力系统负荷预测：主要思路是从过去的负荷中得出对应的DIF值、DEA值、MACD值。然后再通过DIF去估测明天DIF估计值、DEA估计值、MACD估计值。然后又通过DEA、MACD估计值算出一个新的DIF估计值。再将这两个DIF估计值算术平均得出一个新的DIF估计值，然后反推出负荷的预测值，这样就完成了负荷预测。(The main idea is drawn from the past load values corresponding to the DIF, DEA value, MACD value. And then estimate DIF ,DEA,MACD in tomorrow use the past DIF , DEA , MACD. Then through the DEA, MACD calculate a new estimate of DIF. Then the arithmetic average of the two estimated DIF derived a new estimate of DIF, and then introduce predictive value of load, so that is the completion of the load forecast. )

一个无刷直流电机模型及其PIC控制算法模型，可以实际使用。(A brushless DC motor model and PIC model control algorithm can be actually used.)