MatlabCSharpSample

接到单片机上后，输出到示波器可以看到一定频率的方波，通过按键可以调节波形的频率，同时在显示屏上也可以产生对应的周期和频率，外加信号发生器，可以得出对应的周期频率(After being connected to the single chip computer, the square wave of a certain frequency can be seen when it is output to the oscilloscope. The frequency of the waveform can be adjusted by keystrokes. At the same time, the corresponding period and frequency can be generated on the display screen, and the corresponding periodic frequency can be obtained by adding a signal generator.)

ADS1015四路ADC采集驱动程序，使用I2C通信(ADS1015 four-channel ADC acquisition driver, using I2C communication)

A/D转换 在dsp中实现A/D的转换功能(A/D converter)

GNSS接收机通道信息显示控件，用于.NetFramework窗体程序开发，可显示通道捕获、跟踪状态、环路锁定情况、载噪比、卫星号等信息。(GNSS receiver channel information display controls,.NetFramework form for program development, can display the channel capture, tracking state, loop lock, carrier to noise ratio, satellite number and other information.)

说明：  The GPS module has a PC configuration software called u-Center. It can set the parameters of the module and save it to the EEPROM. In fact, it can also be set through the serial communication of the single-chip microcomputer. However, the PC-side setting is more user-friendly and the result can be seen immediately.

《C++程序设计语言》英文版，第3版，C++之父Bjarne Stroustrup著，经典推荐(The C++ Programming Language, Special 3rd Edition, by Bjarne Stroustrup)

STM32F103RBT6上的USB测试程序(STM32F103RBT6 the USB test procedure)

基于LabWindows/CVI的UDP通信(LabWindows/CVI UDP communication)

一个简单的内存池实现算法，使用C++实现，使用VC6.0可以正常编译通过。(A simple memory pool algorithm, using C++ implementation by using VC6.0 to compile correctly.)

DXF轨迹图转G代码，有 直线，圆，圆弧，样条曲线，优化多段线，多段线。与下位机串口通讯！无法编译，是因为要先注册mscomm控件(DXF trajectories turn the G-code, line, circle, arc, spline curves to optimize the polyline, polyline. With lower serial communications! Not compile because the first registered mscomm controls)