three-basic-collaborativ

SOFTWARE FOR ENGINEERS

Multiple input multiple output techniques combined with orthogonal frequency division multiplexing (MIMO-OFDM) provide a promising approach for wireless systems. However, a serious drawback of the OFDM system is the high peak-toaverage power ratio (PAPR), which may severely affect the power efficiency of RF power amplifiers. In this paper, we propose a simple method to reduce the PAPR of MIMO-OFDM signals based on the use of unused subcarriers. Instead of processing the signals at each transmitter separately, a peak cancelling signal is generated at one antenna and is then applied to all the others with only simple modifications. Simulation has shown that a minimum 2 dB reduction in PAPR can be achieved for all transmit signals using this approach. As the signal processing is nearly all done at a single transmitter, repetition of the operations at each transmitter is avoided, and therefore the overall cost of the system can be significantly reduced.

W5100 spi connect describe

Asynchronous Transfer Mode (ATM) is a connection-oriented, packet-switched technology. The packets that are switched in an ATM network are of a fixed length, 53 bytes, and are called cells. The cell size has a particular effect on carrying voice traffic effectively. The ATM Adaptation Layer (AAL) sits between ATM and the variable-length packet protocols that might use ATM, such as IP.

SeaSon from DB-LAB of HIT 介绍的方法是以在cygwin中安装gdb为例说明。(SeaSon from DB-LAB of HIT is based on the method described to install gdb on cygwin an example.)

contains a document about antenna array fundamentals, equation for estimation of array parameters, antenna polar plots. etc

分析仿真了LTE-Advanced系统部署Pico后的小区间干扰协调技术.本文针对在LTE—Advanced系统中部署Pico后恶劣的干扰条件进行了详细的分析，并重点讨论了三种可以有效兼容R8／R9终端的增强型ICIC技术。(Analysis and simulation of LTE-Advanced systems deploy Pico Inter-cell interference coordination techniques for LTE-Advanced systems deploy Pico bad interference conditions, carried out a detailed analysis, and focused on the three can be effectively compatible with R8/R9enhanced terminal ICIC technology.)

详细介绍了西门子PLC的间接寻址方法，对于应用西门子PLC很有用处。(Detailed the the Siemens PLC indirect addressing method is useful for the application of the Siemens PLC.)

有关CC2430的文档，里面的东西很实用，希望对你有帮助(The CC2430 document, which is very useful stuff, want to help you)

RTD25系列源代码，仅供分享，对学习显示器软件的有好处！(RTD25xx source code for you，it is can help you for study LCD Monitor software.)