2010-mathematical-modeling

说明：  To support wireless communication : MIMO

used for clonal selection

这是《Windows高级编程第五版珍藏版》一书中的源码，11-23章，由于源码太大所以分开上传，这是下(This is the " Windows Advanced Programming Fifth Edition Collector' s Edition," a book source, 11-23 chapters, due to too much so upload separate source, which is under)

通过本书可对pso有个全面深入地了解，为工程应用作准备(Through this book on PSO has a comprehensive and in-depth understanding for the engineering applications to prepare)

雷达回波信号检测，LFM信号，脉冲压缩，MTD，相干积累，长线积累，距离走动，速度模糊(Radar echo signal detection, LFM signals, pulse compression, MTD, coherent accumulation of long term accumulation, walking distance and speed)

运用果蝇算法求解FOAGMNN模型程试，代码很详细，感兴趣的人可以看一下(Try using drosophila algorithm FOAGMNN model range, the code is very detailed, interested people can have a look)

Filter Design using matlab

这个是图像匹配的MATLAB算法，大家可以看看阿，还不错，能运行！(this is the image matching algorithm MATLAB, we can look at A, was pretty good, can run!)

交流伺服系统中的死区效应分析与补偿分析了逆变器的死区效应产生的原因及其对交流伺服系统控制性能产生的影响,指出死区补偿的关键 在于电流相位的获取,为了克服实际系统中电流零点的模糊性,提出了一种基于两相静止坐标系下的前馈死 区补偿方法. 该方法通过对三相输出电流一个周期内补偿电压进行傅里叶变换,发现仅需补偿1 ,5 ,7 次谐波 分量即可消除死区效应. 仿真和试验结果验证了这种方法的正确性和可行性.(AC servo system analysis and compensation of dead time effect of the inverter dead time effect causes the impact of the control performance of the AC servo system, and pointed out that the dead time compensation, the key lies in the current phase of the acquisition, in order to overcome the practical zero of the current ambiguity of the system is proposed based on the two-phase stationary coordinate system under the feedforward dead-time compensation method. by the offset voltage of the three-phase output current cycle Fourier transform is found only compensation 1, 5, 7 harmonic components to eliminate the dead time effect. simulation and experimental results verify the correctness and feasibility of this approach.)

按照给定指标采用模拟低通滤波器（巴特沃思低通或者切比雪夫低通）去逼近理想模拟低通滤波器 ，然后通过双线性变换法对模拟滤波器进行数字化，得到数字滤波器 。(According to a given target analog low-pass filter (Butterworth or Chebyshev low-pass low-pass) to approximate the ideal analog low-pass filter, then through the bilinear transformation method to digitize the analog filters, digital filters has been .)